Претраживање
Приказ резултата 1-10 од 42
Anionic clay and hydrotalcite synthesis
(Trans Tech Publications Ltd, Durnten-Zurich, 2002)
Anionic clays are becoming more important for their application as catalysts, ion exchangers and adsorbers and for medical applications as well. Anionic clays are also used as stabilizers of dispersive systems of ceramic ...
Quantitative Formulation of Mechanism of Sintering Process during Creep Deformation of Refractory Concretes
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2009)
This paper is concerned with quantitative formulation of the mechanism of the sintering process during secondary state creep deformation of refractory concretes. Investigated concretes varied in, both, chemical and ...
Static and impact crack properties of a high-strength steel welded joint
(Elsevier Sci Ltd, Oxford, 2007)
in order to gain the benefits of weldable high-strength steels in pressurized equipment applications, satisfactory toughness and crack properties of the welded joint, both in the weld metal and the heat-affected-zone (HAZ), ...
Failure analysis of the end eye connection of the bucket wheel excavator portal tie-rod support
(Pergamon-Elsevier Science Ltd, Oxford, 2009)
This paper describes the failure analysis results of the bucket wheel excavator (BWE) portal tie-rod support. The results of finite elements analysis (FEA) point out the occurrence of pronounced stress concentration, whereby ...
Identification of low cycle fatigue parameters of high strength low-alloy (HSLA) steel at room temperature
(Croatian Metallurgical Soc, Zagreb, 2014)
Low cycle fatigue test was performed in ambient atmosphere at room temperature. cycle loading of material, in case of High strength low-alloy steel, entails modifications of its properties and in this paper is therefore ...
An Artificial Neural Network-based Prediction Model for Utilization of Coal Ash in Production of Fired Clay Bricks: A review
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2021)
This study analyzed the last 20 years' data available on power plant coal ashes used in clay brick production. The statistical analysis has been carried out for a total of 302 cases based on the relevant parameters reported ...
Performances of Vermiculite and Perlite Based Thermal Insulation Lightweight Concretes
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2020)
This experimental study was conducted with an aim to investigate the effect of the elevated temperature on the mineral phase composition, microstructure and mechanical properties of the thermal insulation lightweight ...
Investigation of thermally induced processes in corundum refractory concretes with addition of fly ash
(Springer, Dordrecht, 2015)
The effects that the fly ash addition has on the behavior of thermally resistant corundum concrete were discussed. Experimental program implied production of two refractory composites: "referent" concrete from 20 % of ...
A Kinetic Study of Limestone Dry Micronization in an Ultra-Centrifugal Mill with Peripheral Comminuting Path
(Goller Verlag Gmbh, Baden Baden, 2017)
Because of its physico-mechanical and physico-chemical characteristics, fine-ground (i.e. micronized) limestone is widely applied in the production of new materials. Limestone can be used as a filler, coating and/or powder ...
Evaluation of Lignite Fly Ash for Utilization as Component in Construction Materials
(Taylor & Francis Inc, Philadelphia, 2013)
Utilization potential of fly ash, as the main residue in the lignite coal combustion in Serbian power plants, was investigated in present study. High production of fly ash represents extreme hazard for environment. Question ...