Претраживање
Приказ резултата 1-10 од 38
Drying kinetic simulation of clay tiles made from the raw material having less clay fraction
(Trans Tech Publications Ltd, 2014)
In order to describe the internal moisture rate and to take all different mechanisms of moisture movement into account, it is suitable to use effective diffusivity as a measure of moisture rate, irrespectively of the ...
Quantification of stress raiser influence on decrease of machine parts fatigue life
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
This paper displays the usage of Theory of Critical Distances (TCD) in the prediction of high-cycle fatigue behaviour in machine parts and systems. It is possible to gain real overview of stresses of machine parts by Finite ...
The influence of corrosion on stress concentration factor at shaft to flange radius
(Springer Netherlands, 2013)
This paper describes the influence of corrosion on stress concentration factor and crack initiation at shaft-flange transition section. The real turbine shaft failure case study is used for research. This case study and ...
Prediction of crack initiation in spur gear contact zone
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
The objective of this paper is to give a new viewpoint in contact fatigue prediction in the case of high-cycle fatigue. The presented research is based on up-to-date methods and multidisciplinary approach, and enables ...
Determination of LCF Plastic and Elastic Strain Components of Steel
(Springer Science and Business Media B.V., 2022)
The behavior of steel in low-cycle fatigue (LCF) is tested experimentally, in accordance with ISO 12106:2017 (E) and/or ASTM E 606-04. For this purpose, smooth specimens which are exposed to low-cycle fatigue at several ...
Mix design and engineering properties of ultra high performance self compacting concrete
(Czech Concrete Soc-Ceska Betonarska Spolecnost Cssi, Prague 1, 2011)
The mechanical properties (compressive strength and flexural strength) were investigated under different curing conditions (standard and steam curing). Silica fumes have characteristics that make them necessary in cement ...
Analysis of current state and integrity evaluation for the supply tank of generation unit 6 of thermal power plant Nikola Tesla ”A”, Obrenovac
(Trans Tech Publications Ltd, 2014)
Stable supply tank, with volume V = 250 m3 and operating pressure p = 1,5 MPa, of generation unit 6 at thermal power plant 'Nikola Tesla A' in Obrenovac, is designed for water-steam working fluid. It was made of steel Č ...
Investigation of the Repair Welding Technology Using Ni Base Electrode
(Trans Tech Publications Ltd, Durnten-Zurich, 2013)
Metal materials are subjected to innumerable time-dependent degradation mechanisms when operate in power, petrochemical and refinery plant. These materials are subjected to multiaxial stresses, creep, fatigue, corrosion ...
Methodology for reparation of damaged sleeves and welded shield sections of guide vanes at hydropower plant DJERDAP 1
(Trans Tech Publications Ltd, 2014)
Vertical Kaplan turbines, manufactured in Russia and with nominal power of 200 MW, have been installed in 6 hydroelectric generating units at ’Djerdap 1’. During the refurbishment of hydropower plant experimental non-destructive ...
Influence of Si content and cooling rates on the size of SDAS and the latent heat released in Al-Si(5-11)-Cu1 alloys
(Proceedings - European Metallurgical Conference, EMC 2007, 2007)
The latent heat of solidification of any alloy depends on the chemistry and the microstructure developed during solidification process. Effects of chemistry on the release of the latent heat during solidification and ...