Претраживање
Приказ резултата 41-50 од 198
Determination of apparent porosity level of refractory concrete using ultrasonic pulse velocity technique and image analysis
(American Ceramic Society, 2011)
Aim of this paper is to establish the correlation between sintering process, porosity and important thermo-mechanical property of refractory concrete, i.e. creep. Creep deformation was investigated according to standard ...
HSLA Steel - Simulation of Fatigue
(Springer, 2020)
In present paper, based on the results of the experimental study of the behaviour of the samples made of a HSLA steel, in the form of round smooth specimens (RSS) under LCF conditions (with controlled and completely ...
The failures of a supporting structure of a coal-reloading bridge and methodological approach to recovery of the damages
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
In present paper, methodological approach to the analysis of the failures and recovery of the damages has been presented on an example of fracture and damage of a structure of the reloading bridge. The approach presented ...
Optimization of bentonite clay mechano-chemical activation using artificial neural network modeling
(Elsevier Sci Ltd, Oxford, 2017)
The properties of seven montmorillonite-rich bentonites of different geological origin were investigated prior and subsequent to mechano-chemical processing in an ultra-centrifugal mill. The objective of the experiment was ...
Optimization of drying through analytical modeling: clays as bonding agents in refractory materials
(Elsevier Sci Ltd, Oxford, 2016)
The objective of this study was to investigate the clay drying as a unit operation in the refractory materials processing. Two clays that varied in chemical and mineralogical compositions were experimentally tested in a ...
Some properties of concrete based on recycled bricks
(Revista Romana de Materiale/ Romanian Journal of Materials, 2010)
By using crushed brick as aggregate, the structure of concrete can be effectively modeled and materials with very different physical-mechanical characteristics can be obtained. Determination of the influence of polymer ...
Determination of the optimal drying condition during drying of green masonry products
(ModTech Publishing House, 2012)
Explanation of the drying process is reduced to the establishment of a series theoretical and empirical drying models. Complex processes of simultaneous mass and energy transfer, which are often non-stationary and the ...
Effects of mechanical-activation and TiO2 addition on the behavior of two-step sintered steatite ceramics
(Elsevier Sci Ltd, Oxford, 2019)
Steatite, as ceramic with composition predominantly resting on magnesium silicate, was produced from economic resources - talc, aluminosilicate clays, and either BaCO3 or feldspar as flux. Titanium dioxide was a doping ...
Optimization of the production process through response surface method: Bricks made of loess
(Elsevier Sci Ltd, Oxford, 2013)
Loess clays are commonly used to produce bricks. Heavy clays, taken at location near Zrenjanin, Serbia, are used as a representative raw material in this study. The sample, containing about 28% of clay sized particles, is ...
Effect of LCF on behavior and microstructure of microalloyed HSLA steel and its simulated CGHAZ
(Pergamon-Elsevier Science Ltd, Oxford, 2019)
Numerous structural components made of high strength low-alloyed steels are often exposed to low-cycle fatigue loading during their exploitation life. In order to study the fatigue behavior of one grade of structural steels ...