Претраживање
Приказ резултата 31-40 од 42
Possibilities of producing solid bricks from mixtures of plastic brick clay and fly ash
(Trans Tech Publications Ltd, Durnten-Zurich, 2004)
The paper briefly reviews results of laboratory testing performed in order to establish the possibility of adopting the process of production of solid bricks from plastic clay and fly ash. The experimental results substantiated ...
The influence of the raw material grinding fineness on the brick industry products quality
(Trans Tech Publications Ltd, Durnten-Zurich, 2002)
The brick industry development trends have two main directions: high product quality and use of lower quality clays and secondary (recycled) raw materials, The development trends reflect today's market requirements - ...
Impact of choice of stabilized hysteresis loop on the end result of investigation of high-strength low-alloy (HSLA) steel on low cycle fatigue
(Croatian Metallurgical Soc, Zagreb, 2014)
High strength low-alloy steel under low cycle fatigue at a certain level of strain controlled achieve stabilized condition. During the fatigue loading stabilized hysteresis loop is determined, which typical cycle of ...
Failure analysis of the end eye connection of the bucket wheel excavator portal tie-rod support
(Pergamon-Elsevier Science Ltd, Oxford, 2009)
This paper describes the failure analysis results of the bucket wheel excavator (BWE) portal tie-rod support. The results of finite elements analysis (FEA) point out the occurrence of pronounced stress concentration, whereby ...
An Artificial Neural Network-based Prediction Model for Utilization of Coal Ash in Production of Fired Clay Bricks: A review
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2021)
This study analyzed the last 20 years' data available on power plant coal ashes used in clay brick production. The statistical analysis has been carried out for a total of 302 cases based on the relevant parameters reported ...
Performances of Vermiculite and Perlite Based Thermal Insulation Lightweight Concretes
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2020)
This experimental study was conducted with an aim to investigate the effect of the elevated temperature on the mineral phase composition, microstructure and mechanical properties of the thermal insulation lightweight ...
Failure analysis of hydraulic turbine shaft
(Pergamon-Elsevier Science Ltd, Oxford, 2012)
This paper describes the analysis of major failure of 28 MW horizontal hydro turbine shaft. The analysis of load carrying capacity of critical radius and fractography analysis are presented. Special emphasize is on ...
Thermal and Mechanical Behavior of Composite Mortars Containing Natural Sorptive Clays and Fly Ash
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2019)
Mineral additives are extensively applied as cement replacement materials in both construction concrete and mortar. Fly ash is one of the most commonly utilized additives which improve Theological properties, as well as ...
Novel Approach for Determination of Potentially Toxic Elements via ICP-OES in Aqueous Solutions of Building Materials with Industrial Byproduct Addition
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2019)
New global tendencies for waste materials reusing in building materials are imposing the request for improved performances of chemical analysis methods and the improvements of matrices used. A new method for optical emission ...
Mechanical Properties and Microstructure Fractal Analysis of Refractory Bauxite Concrete
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2015)
The surface topography analysis via fractals as a means of explanation of composite materials mechanical and microstructural characteristics has hardly been reported so far. This study proposes a method of fractal analysis ...