Претраживање
Приказ резултата 21-30 од 71
Physical-Mechanical Properties of Cement Stabilized RAP/Crushed Stone Aggregate Mixtures
(Univ Osijek, Tech Fac, Slavonski Brod, 2019)
The paper presents and analyzes the results of testing the properties of cement stabilized mixtures of reclaimed asphalt pavement (RAP) and crushed stone aggregate (CSA). Tests were carried out on reclaimed asphalt pavement ...
Characterisation of high-carbon steel surface welded layer
(Strojniski Vestnik/Journal of Mechanical Engineering, 2010)
In this paper microstructural and mechanical properties of high-carbon steel surface welded layer, obtained with self-shielded flux cored wire, are presented in the case of a standard rails and crossings. The testing results ...
Concrete mix design for reconstruction of northwest breakwater in the Tripoli harbour - Libya
(Faculty of Mechanical Engineering in Slavonski Brod, Faculty of Electrical Engineering in Osijek, Faculty of Civil Engineering in Osijek, 2011)
Reconstruction of Northwest breakwater in the Tripoli Harbour - Libya (about 4500 m long) required manufacture of various concrete elements (cubes and accropodes) in total amount of 550 000 m(3). Volumes of cubes were 6,3 ...
Mechanical properties of ultra high performance self compacting concrete with different mineral admixtures
(Revista Romana de Materiale/ Romanian Journal of Materials, 2011)
Preparation and microstructure of ultra high performance concrete (UHPC) have been intensively analyzed In the last few years. The mechanical properties (compressive strength and flexural strength) were investigated under ...
Determination of recycled aggregate concrete degradation by resonance frequency analysis
(Revista Romana de Materiale/ Romanian Journal of Materials, 2011)
The evaluation of the dynamic modulus of elasticity of twelve different concrete mix proportions as a function of the density and degradations due to freeze/thaw cycles is presented in this paper. Pore system and saturation ...
Determination of the apparent porosity level of refractory concrete during a sintering process using an ultrasonic pulse velocity technique and image analysis
(Savez hemijskih inženjera, Beograd, 2010)
Concrete which undergoes a thermal treatment before (pre-casted concrete blocks) and during (concrete embedded in-situ) its life-service can be applied in plants operating at high temperature and as thermal insulation. ...
Influence of the phase composition of refractory materials on creep
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2006)
In this paper, the relationship between the creeping effect and mineralogical characteristics of the applied binding phase for various refractory materials (high-alumina materials, with high or low impurity content, tar ...
Structural Integrity Assessment of Welded Pressure Vessel Produced of HSLA Steel
(Journal Iron Steel Research Editorial Board, Beijing, 2011)
Welded joint is a critical region of a welded structure. The operational safety of welded pressure equipment mostly depends on the behaviour of loaded weldments. Safety of welded structure is dependent on the properties ...
Synthesizing a new type of mullite lining
(Inst Za Kovinske Materiale I In Tehnologie, Ljubjana, 2013)
Various possibilities for developing new mullite-based refractory linings that can be applied in a casting process were investigated and are presented in this paper. An optimization of the refractory-lining composition ...
Influence of increased temperature on clay fast drying process
(Revista Romana de Materiale/ Romanian Journal of Materials, 2009)
In this paper are presented testing results during process of fast drying at conditions of increased temperature. Three different masonry raw materials were examined using recircular laboratory dryer with air recirculation. ...