Претраживање
Приказ резултата 21-30 од 375
Analysis of the cause of the girth gear tooth fracture occurrence at the bucket wheel excavator
(Elsevier, Amsterdam, 2019)
Premature damages and fractures of components and structures of bucket-wheel excavators at open-pit mine often occur in exploitation, caused either by inadequate design or insufficient knowledge of the material properties, ...
Influence of Si content and cooling rates on the size of SDAS and the latent heat released in Al-Si(5-11)-Cu1 alloys
(Proceedings - European Metallurgical Conference, EMC 2007, 2007)
The latent heat of solidification of any alloy depends on the chemistry and the microstructure developed during solidification process. Effects of chemistry on the release of the latent heat during solidification and ...
Some experience of concrete design in marine structures
(Thomas Telford Services Ltd, 2005)
For reconstruction of northwest breakwater in Tripoli harbour / Libya, about 4500 m long, it is necessary to produce various concrete elements (cubes and accropodes) in total amount of 550000 m 3 . Volumes of cubes are ...
Sulphur concrete
(Structural Engineering Conferences, SECON, 2007)
Sulphur concrete is a relatively new material, and although similar in final appearance to portland cement concrete, its manufacture, handling, use, and testing are different. Sulphur concrete is a thermoplastic material ...
Linings based chromite for application in foundry
(ModTech Publishing House, 2012)
In this work, a possibility to develop new chromite-based refractory linings for casting applications has been examined. Lining composition optimization with the controlled reologic properties was achieved by applying ...
Indicators of HSLA steel behavior under low cycle fatigue loading
(Elsevier Science Bv, Amsterdam, 2016)
In present paper, the experimental research of the behaviour of high-strength low-alloy steel (HSLA) exposed to low-cycle fatigue (LCF) with controlled and fully reversible strain (Delta epsilon/2 = const, R epsilon = ...
Microstructure analysis and crack detection in turbine blades after prolonged exposure in plant
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
Turbine blades are one of the most important machine parts in every power generator. Corrosion and/or erosion attack on blades are also available in moisture atmosphere, because the wet water vapour is an usual working ...
Review of results of interlaboratory comparisons of national accredited laboratorys in the free field noise level measurements
(IEEE, NEW YORK, 2015)
Interlaboratory comparisons in the field of enviromental noise level measurements were organized by IMS Institute in Belgrade in August this year as a part of the standard noise monitoring according to of the method given ...
Establishing a method for determination of effective diffusion coefficiente
(ModTech Publishing House, 2011)
The aim of this paper is to calculate the effective diffusion coefficient for typical masonry clay on the base of experimentally recorded drying curves. Two computer programs for calculation of diffusion coefficient, which ...
Integrated LCA and LCCA network level pavement maintenance model
(CRC Press/Balkema, 2019)
Pavement management systems tend to lead to sound decision making regarding the optimal maintenance strategy which is, in most cases, based on the achievement of minimal total society costs which are defined as the sum of ...