Pretraživanje
Prikaz rezultata 21-30 od 375
Low cycle fatigue of weldments produced of a high strength low alloyed steel
(Elsevier Science Bv, Amsterdam, 2014)
A quenched and tempered high strength low alloy steel NIONIKRAL 70 for producing welded pressure vessels, where high resistance to fatigue crack propagation and high tolerance of damage are of high importance, has been ...
Compressive Strength Improvements of Cement-Based Composites Achieved with Additional Milling of Metakaolin
(Springer, Dordrecht, 2018)
Kaolin from a Serbian deposit, having a high content of mica and quartz, disordered kaolinite and a high specific surface area, was used to prepare metakaolin (MK). The calcination at temperatures of 700 degrees C or 750 ...
Properties of the Cement-Based Composites with High Content of Metakaolin
(Springer, Dordrecht, 2018)
Environmental concerns and sustainable development require increased replacement of cement. Most of previous studies have shown that the compressive strength of cement-based composites is maximized with a 20% content of ...
The comparative analysis of thermal behaviour of a different thicknesses walls made from autoclaved aerated concrete blocks exposed to fire
(Proceedings of the 19th International Symposium MASE, Ohrid, 2022, 2022)
In this paper a comparative analysis of thermal behavior of six partition walls with different
thicknesses were presented. The walls were dimensions 3000 mm x 3000 mm made from autoclaved
aerated concrete blocks with ...
State Analysis and Integrity of Welded Structures of the Upper Ring of the Turbine Runner Guide Vane Apparatus of Hydroelectric Generating Set A6 on Hydro Power Plant Djerdap 1
(Trans Tech Publications Ltd, Durnten-Zurich, 2013)
During the refurbishment of the hydroelectric generating set A6 on HPP "Djerdap 1", for the state analysis and assessment of the level and causes of degradation of the structure of the vertical Kaplan turbine runner guide ...
Prediction model for the cost of road rehabilitation and reconstruction works
(Univ Zagreb, Fac Civil Engineering, Zagreb, 2012)
Maintenance of existing road network represents a challenge for public road authorities who seek a balance between available budgets and the need for maintaining level of service at a satisfactory level on existing road ...
Drying Process Modelling for Heavy Clay Products Using a New Thin Layer Drying Model
(Trans Tech Publications Ltd, Stafa-Zurich, 2013)
Drying results, determined on samples made of masonry clay from the locality "Banatski Karlovac", are presented in this study. Experimental investigations were carried out in a laboratory recirculation dryer in which drying ...
Analysis of the cause of the girth gear tooth fracture occurrence at the bucket wheel excavator
(Elsevier, Amsterdam, 2019)
Premature damages and fractures of components and structures of bucket-wheel excavators at open-pit mine often occur in exploitation, caused either by inadequate design or insufficient knowledge of the material properties, ...
Characterization of drying behavior and modeling of industrial drying process
(IOP Publishing Ltd, Bristol, 2020)
The general method for industrial chamber dryer optimization was reported in this paper. The first step in finding the most suitable drying regime is to characterized the clay raw material, especially its water loss at ...
X-ray fluorescence spectroscopy of eggshells as a potential raw material in the construction industry
(Serbian Ceramic Society Conference “Advanced Ceramic and Application XI – New frontiers in multifunctional material science and processing”, Book of Abstracts, 2023)
Due to its chemical composition based on CaCO3 and low price, eggshells, as waste from one of the most widely consumed foods worldwide, are receiving increased attention in building and construction industry studies. The ...