TY  - JOUR
AU  - Terzić, Anja
AU  - Obradović, Nina
AU  - Pouchly, Vaclav
AU  - Stojanović, Jovica
AU  - Maca, Karel
AU  - Pavlović, Vladimir
PY  - 2018
UR  - http://rims.institutims.rs/handle/123456789/340
AB  - The influence of the sintering method on the mineral phase transformations and development of the crystalline microstructure of steatite ceramics was investigated. The steatite samples were fabricated from talc and bentonite as low-cost raw materials. Feldspar and barium carbonate, as fluxing agents, were altered in the steatite composition. Dilatometric analysis was applied in the monitoring of the dimensional changes and thereby densification of steatite during the traditional sintering (TS) procedure up to 1200 degrees C. Spark plasma sintering (SPS) method was used under the following sintering conditions: 100 degrees C/min heating rate, uniaxial pressure of 50 MPa; sintering temperature 800 degrees C/1 min or 1000 degrees C/2 min. Crystallinity changes and mineral phase transition during sintering were observed by X-ray diffraction technique. Microstructural visualization of the samples and the spatial arrangements of individual chemical elements were achieved via scanning electron microscopy equipped with the EDS mapping. It was found that SPS sintering facilitated all microstructural changes during high temperature treatment and shifted them to lower temperatures. SPS treatment conducted at 1000 degrees C resulted in maximum densification of the steatite powder compacts and the formation stabilized protoenstatite structure.
PB  - Međunarodni Institut za nauku o sinterovanju, Beograd
T2  - Science of Sintering
T1  - Microstructure and Phase Composition Of Steatite Ceramics Sintered by Traditional and Spark Plasma Sintering
EP  - 312
IS  - 3
SP  - 299
VL  - 50
DO  - 10.2298/SOS1803299T
ER  - 

@article{
author = "Terzić, Anja and Obradović, Nina and Pouchly, Vaclav and Stojanović, Jovica and Maca, Karel and Pavlović, Vladimir",
year = "2018",
abstract = "The influence of the sintering method on the mineral phase transformations and development of the crystalline microstructure of steatite ceramics was investigated. The steatite samples were fabricated from talc and bentonite as low-cost raw materials. Feldspar and barium carbonate, as fluxing agents, were altered in the steatite composition. Dilatometric analysis was applied in the monitoring of the dimensional changes and thereby densification of steatite during the traditional sintering (TS) procedure up to 1200 degrees C. Spark plasma sintering (SPS) method was used under the following sintering conditions: 100 degrees C/min heating rate, uniaxial pressure of 50 MPa; sintering temperature 800 degrees C/1 min or 1000 degrees C/2 min. Crystallinity changes and mineral phase transition during sintering were observed by X-ray diffraction technique. Microstructural visualization of the samples and the spatial arrangements of individual chemical elements were achieved via scanning electron microscopy equipped with the EDS mapping. It was found that SPS sintering facilitated all microstructural changes during high temperature treatment and shifted them to lower temperatures. SPS treatment conducted at 1000 degrees C resulted in maximum densification of the steatite powder compacts and the formation stabilized protoenstatite structure.",
publisher = "Međunarodni Institut za nauku o sinterovanju, Beograd",
journal = "Science of Sintering",
title = "Microstructure and Phase Composition Of Steatite Ceramics Sintered by Traditional and Spark Plasma Sintering",
pages = "312-299",
number = "3",
volume = "50",
doi = "10.2298/SOS1803299T"
}

Terzić, A., Obradović, N., Pouchly, V., Stojanović, J., Maca, K.,& Pavlović, V.. (2018). Microstructure and Phase Composition Of Steatite Ceramics Sintered by Traditional and Spark Plasma Sintering. in Science of Sintering
Međunarodni Institut za nauku o sinterovanju, Beograd., 50(3), 299-312.
https://doi.org/10.2298/SOS1803299T

Terzić A, Obradović N, Pouchly V, Stojanović J, Maca K, Pavlović V. Microstructure and Phase Composition Of Steatite Ceramics Sintered by Traditional and Spark Plasma Sintering. in Science of Sintering. 2018;50(3):299-312.
doi:10.2298/SOS1803299T .

Terzić, Anja, Obradović, Nina, Pouchly, Vaclav, Stojanović, Jovica, Maca, Karel, Pavlović, Vladimir, "Microstructure and Phase Composition Of Steatite Ceramics Sintered by Traditional and Spark Plasma Sintering" in Science of Sintering, 50, no. 3 (2018):299-312,
https://doi.org/10.2298/SOS1803299T . .