Претраживање
Приказ резултата 21-30 од 63
Mechanical properties of ultra high performance self compacting concrete with different mineral admixtures
(Revista Romana de Materiale/ Romanian Journal of Materials, 2011)
Preparation and microstructure of ultra high performance concrete (UHPC) have been intensively analyzed In the last few years. The mechanical properties (compressive strength and flexural strength) were investigated under ...
Determination of recycled aggregate concrete degradation by resonance frequency analysis
(Revista Romana de Materiale/ Romanian Journal of Materials, 2011)
The evaluation of the dynamic modulus of elasticity of twelve different concrete mix proportions as a function of the density and degradations due to freeze/thaw cycles is presented in this paper. Pore system and saturation ...
Determination of the apparent porosity level of refractory concrete during a sintering process using an ultrasonic pulse velocity technique and image analysis
(Savez hemijskih inženjera, Beograd, 2010)
Concrete which undergoes a thermal treatment before (pre-casted concrete blocks) and during (concrete embedded in-situ) its life-service can be applied in plants operating at high temperature and as thermal insulation. ...
Structural Integrity Assessment of Welded Pressure Vessel Produced of HSLA Steel
(Journal Iron Steel Research Editorial Board, Beijing, 2011)
Welded joint is a critical region of a welded structure. The operational safety of welded pressure equipment mostly depends on the behaviour of loaded weldments. Safety of welded structure is dependent on the properties ...
Synthesizing a new type of mullite lining
(Inst Za Kovinske Materiale I In Tehnologie, Ljubjana, 2013)
Various possibilities for developing new mullite-based refractory linings that can be applied in a casting process were investigated and are presented in this paper. An optimization of the refractory-lining composition ...
The influence of silica fume and curing regime on some properties of concrete
(Revista Romana de Materiale/ Romanian Journal of Materials, 2014)
The investigation of posibilities of concrete structure modification by silica fume to improve concrete properties was presented in this report. Percentage of silica fume in regard to cement varied between 0% and 20%. ...
Life extension of gears flank surfaces regenerated by hard facing
(Editura Stiintifica Fmr, Bucharest, 2013)
This paper contains the results of experimental analysis of fatigue endurance of used steel teeth regenerated by hard facing. The cylindrical spur gears were tested and compared with the newly made ones, oiler being ...
Buckling resistance of stainless steel angle column
(Union of Croatian Civil Engineers and Technicians, 2019)
A numerical study of compressive capacities of stainless steel angle columns is presented in the paper in order to assess the design procedures presented in Eurocode 3. The study focuses on pin-ended hot-rolled equal angle ...
The Chemometric Study of Limestone Physico-chemical Properties and Thermal Behavior for Application in Construction Composites
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2017)
The limestone, as an economically sustainable and easily available basic raw material, is frequently utilized in the building industry for resolving of the environmental protection issues. The limestone is incorporated in ...
Sintering of Fly Ash Based Composites with Zeolite and Bentonite Addition for Application in Construction Materials
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2017)
Due to pozzolanic characteristics, fly ash is commonly used as a cement replacement in construction composites. Addition of natural clays with sorption ability (i.e. zeolite and bentonite) in to the fly ash based construction ...