Pretraživanje
Prikaz rezultata 11-20 od 29
Failure analysis of hydraulic turbine shaft
(Pergamon-Elsevier Science Ltd, Oxford, 2012)
This paper describes the analysis of major failure of 28 MW horizontal hydro turbine shaft. The analysis of load carrying capacity of critical radius and fractography analysis are presented. Special emphasize is on ...
Procedure for setting up the drying regime that is consistent with the nature and properties of the clay raw material
(Taylor & Francis Inc, Philadelphia, 2018)
Over the past three decades, traditional ceramic facilities, such as chamber and tunnel dryers, are improved. Better thermotechnical equipment, operational strategies, and reliable scale-up methodologies have lead to higher ...
The main factors influencing canine demodicosis treatment outcome and determination of optimal therapy
(Springer, New York, 2015)
The main idea of this research was to evaluate the efficacy of canine demodicosis conventional treatments using mathematical analyses. All available papers published between 1980 and 2014 were used in this study. One hundred ...
Geometry, mechanical properties and mounting of perforated plates for ballistic application
(Elsevier Sci Ltd, Oxford, 2010)
In this paper, the ballistic resistance of perforated plates made of different types of steel, mounting and geometry was investigated. Different types of steel in various heat treatment conditions were tested. Target ...
Wire fence as applique armour
(Elsevier Sci Ltd, Oxford, 2010)
In this paper, the behaviour of wire fence was investigated for potential as applique armour. The wire fence used was made from commercial high-strength patented wire and the supporting frames were made of mild steel ...
Evaluation of Lignite Fly Ash for Utilization as Component in Construction Materials
(Taylor & Francis Inc, Philadelphia, 2013)
Utilization potential of fly ash, as the main residue in the lignite coal combustion in Serbian power plants, was investigated in present study. High production of fly ash represents extreme hazard for environment. Question ...
Investigation of thermally induced processes in corundum refractory concretes with addition of fly ash
(Springer, Dordrecht, 2015)
The effects that the fly ash addition has on the behavior of thermally resistant corundum concrete were discussed. Experimental program implied production of two refractory composites: "referent" concrete from 20 % of ...
A Kinetic Study of Limestone Dry Micronization in an Ultra-Centrifugal Mill with Peripheral Comminuting Path
(Goller Verlag Gmbh, Baden Baden, 2017)
Because of its physico-mechanical and physico-chemical characteristics, fine-ground (i.e. micronized) limestone is widely applied in the production of new materials. Limestone can be used as a filler, coating and/or powder ...
The influence of the raw material grinding fineness on the brick industry products quality
(Trans Tech Publications Ltd, Durnten-Zurich, 2002)
The brick industry development trends have two main directions: high product quality and use of lower quality clays and secondary (recycled) raw materials, The development trends reflect today's market requirements - ...
Preparation of flish sediments and their application in brick products manufacturing
(Trans Tech Publications Ltd, Durnten-Zurich, 2004)
Flish sediments represent atypical raw materials: marls, marly shales and shales. This paper presents the results of laboratory tests of shales. The paper points out the similarities and differences in technological ...