Search
Now showing items 1-10 of 31
Experimental and numerical thermo - mechanical analysis of friction stir welding of high - strength alluminium alloy
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
This paper presents experimental and numerical analysis of the change of temperature and force in the vertical direction during the friction stir welding of high-strength aluminium alloy 2024 T3. This procedure confirmed ...
Synthesis and characterization of new refractory coatings based on talc, cordierite, zircon and mullite fillers for lost foam casting process
(Polska Akad Nauk, Polish Acad Sciences, Inst Metall & Mater Sci Pas, Warszawa, 2014)
Refractory coatings based on different refractory fillers (talc, cordierite, zircon and mullite) for application in Lost Foam casting process were investigated. Design and optimization of the coatings composition with ...
Investigation of thermally induced processes in corundum refractory concretes with addition of fly ash
(Springer, Dordrecht, 2015)
The effects that the fly ash addition has on the behavior of thermally resistant corundum concrete were discussed. Experimental program implied production of two refractory composites: "referent" concrete from 20 % of ...
A Kinetic Study of Limestone Dry Micronization in an Ultra-Centrifugal Mill with Peripheral Comminuting Path
(Goller Verlag Gmbh, Baden Baden, 2017)
Because of its physico-mechanical and physico-chemical characteristics, fine-ground (i.e. micronized) limestone is widely applied in the production of new materials. Limestone can be used as a filler, coating and/or powder ...
Identification of low cycle fatigue parameters of high strength low-alloy (HSLA) steel at room temperature
(Croatian Metallurgical Soc, Zagreb, 2014)
Low cycle fatigue test was performed in ambient atmosphere at room temperature. cycle loading of material, in case of High strength low-alloy steel, entails modifications of its properties and in this paper is therefore ...
Cavitation damages morphology of high-strength low-alloy steel
(Faculty of Metallurgy, 2016)
This paper presents the research into behaviour of HSLA steel affected by cavitation. The parent material (PM) and simulated heat-affected zone (SHAZ) were studied. Ultrasonic vibratory cavitation test was performed in ...
Impact of choice of stabilized hysteresis loop on the end result of investigation of high-strength low-alloy (HSLA) steel on low cycle fatigue
(Croatian Metallurgical Soc, Zagreb, 2014)
High strength low-alloy steel under low cycle fatigue at a certain level of strain controlled achieve stabilized condition. During the fatigue loading stabilized hysteresis loop is determined, which typical cycle of ...
Geometry, mechanical properties and mounting of perforated plates for ballistic application
(Elsevier Sci Ltd, Oxford, 2010)
In this paper, the ballistic resistance of perforated plates made of different types of steel, mounting and geometry was investigated. Different types of steel in various heat treatment conditions were tested. Target ...
Wire fence as applique armour
(Elsevier Sci Ltd, Oxford, 2010)
In this paper, the behaviour of wire fence was investigated for potential as applique armour. The wire fence used was made from commercial high-strength patented wire and the supporting frames were made of mild steel ...
Evaluation of Lignite Fly Ash for Utilization as Component in Construction Materials
(Taylor & Francis Inc, Philadelphia, 2013)
Utilization potential of fly ash, as the main residue in the lignite coal combustion in Serbian power plants, was investigated in present study. High production of fly ash represents extreme hazard for environment. Question ...