Претраживање
Приказ резултата 21-30 од 198
Characterization of serbian raw clay materials based on >0.63 mm sieve residues
(InterCeram: International Ceramic Review, 2009)
Particle size is the effective diameter of a particle as measured by sedimentation, sieving, or micrometric methods. Particle sizes are expressed as classes with specific, effective diameter class limits. The main classes ...
Structural Integrity Assessment of Welded Pressure Vessel Produced of HSLA Steel
(Journal Iron Steel Research Editorial Board, Beijing, 2011)
Welded joint is a critical region of a welded structure. The operational safety of welded pressure equipment mostly depends on the behaviour of loaded weldments. Safety of welded structure is dependent on the properties ...
Characterization of raw clay materials in Serbia 0.063mm sieved residues
(American Ceramic Society, 2009)
Particle size is the effective diameter of a particle as measured by sedimentation, sieving, or micrometric methods. Particle sizes are expressed as classes with specific, effective diameter class limits. The broad classes ...
Recommendations for choice of coefficients in pile bearing capacity
(ASCE - American Society of Civil Engineers, 2002)
In this paper we have shown results of research on the influence of the geotechnical environment on pile bearing capacity. Experimental research was carried out at full scale and consisted of test loading of 3 (three) ...
Influence of different bonding and fluxing agents on the sintering behavior and dielectric properties of steatite ceramic materials
(Elsevier Sci Ltd, Oxford, 2017)
The focus of the study was on providing insights into interconnections between sintering and development of the crystalline microstructure, and consequently variations in dielectric behavior of four steatites fabricated ...
Investigation of thermally induced processes in corundum refractory concretes with addition of fly ash
(Springer, Dordrecht, 2015)
The effects that the fly ash addition has on the behavior of thermally resistant corundum concrete were discussed. Experimental program implied production of two refractory composites: "referent" concrete from 20 % of ...
Primena postupka mehaničke aktivacije u procesu pripreme neplastičnih opekarskih sirovina / Application of mechanical activation treatment within the preparation process of masonaray clay raw materials
(Udruženje inženjera građevinarstva, geotehnike, arhitekture i urbanista "Izgradnja", Beograd, 2011)
U radu je dat uporedni prikaz eksperimentalno utvrđenih rezultata svojstava opekarske sirovine, koja je bila pripremljena standardnim postupkom prerade i postupkom mehaničke aktivacije. Uobičajeni standardni postupak prerade ...
The influence of silica fume and curing regime on some properties of concrete
(Revista Romana de Materiale/ Romanian Journal of Materials, 2014)
The investigation of posibilities of concrete structure modification by silica fume to improve concrete properties was presented in this report. Percentage of silica fume in regard to cement varied between 0% and 20%. ...
Life extension of gears flank surfaces regenerated by hard facing
(Editura Stiintifica Fmr, Bucharest, 2013)
This paper contains the results of experimental analysis of fatigue endurance of used steel teeth regenerated by hard facing. The cylindrical spur gears were tested and compared with the newly made ones, oiler being ...
A Kinetic Study of Limestone Dry Micronization in an Ultra-Centrifugal Mill with Peripheral Comminuting Path
(Goller Verlag Gmbh, Baden Baden, 2017)
Because of its physico-mechanical and physico-chemical characteristics, fine-ground (i.e. micronized) limestone is widely applied in the production of new materials. Limestone can be used as a filler, coating and/or powder ...