Претраживање
Приказ резултата 31-40 од 42
Impact of choice of stabilized hysteresis loop on the end result of investigation of high-strength low-alloy (HSLA) steel on low cycle fatigue
(Croatian Metallurgical Soc, Zagreb, 2014)
High strength low-alloy steel under low cycle fatigue at a certain level of strain controlled achieve stabilized condition. During the fatigue loading stabilized hysteresis loop is determined, which typical cycle of ...
Failure analysis of the end eye connection of the bucket wheel excavator portal tie-rod support
(Pergamon-Elsevier Science Ltd, Oxford, 2009)
This paper describes the failure analysis results of the bucket wheel excavator (BWE) portal tie-rod support. The results of finite elements analysis (FEA) point out the occurrence of pronounced stress concentration, whereby ...
Static and impact crack properties of a high-strength steel welded joint
(Elsevier Sci Ltd, Oxford, 2007)
in order to gain the benefits of weldable high-strength steels in pressurized equipment applications, satisfactory toughness and crack properties of the welded joint, both in the weld metal and the heat-affected-zone (HAZ), ...
Anionic clay and hydrotalcite synthesis
(Trans Tech Publications Ltd, Durnten-Zurich, 2002)
Anionic clays are becoming more important for their application as catalysts, ion exchangers and adsorbers and for medical applications as well. Anionic clays are also used as stabilizers of dispersive systems of ceramic ...
Correlation among sintering process, porosity, and creep deformation of refractory concrete
(Springer, New York, 2009)
The aim of this paper is to establish the correlation among sintering process, porosity, and important thermo-mechanical property of refractory concrete, i.e., creep. Creep deformation was investigated according to the ...
Quantitative Formulation of Mechanism of Sintering Process during Creep Deformation of Refractory Concretes
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2009)
This paper is concerned with quantitative formulation of the mechanism of the sintering process during secondary state creep deformation of refractory concretes. Investigated concretes varied in, both, chemical and ...
Influence of FSW parameters on formation quality and mechanical properties of Al 2024-T351 butt welded joints
(Elsevier, Amsterdam, 2013)
The influence of R/v ratio on joint quality in 2024-T351 aluminum alloy was studied. Specimens were subjected to friction stir welding with the rotation rates of 750, 950 and 1180 r/min and welding speed between 73 and 190 ...
Has the latest global financial crisis changed the way road public-private partnerships are funded? A comparison of Europe and Latin America
(Elsevier Sci Ltd, Oxford, 2020)
A financial/economic crisis may have an adverse effect on transport public-private partnerships (PPPs) as both traffic demand is negatively influenced, and governments are further under pressure. However, research on awarded ...
Cavitation damages morphology of high-strength low-alloy steel
(Faculty of Metallurgy, 2016)
This paper presents the research into behaviour of HSLA steel affected by cavitation. The parent material (PM) and simulated heat-affected zone (SHAZ) were studied. Ultrasonic vibratory cavitation test was performed in ...
Dehydration investigations of a refractory concrete using DTA method
(Springer, Dordrecht, 2012)
The base mix refractory concrete is corundum-based, containing corundum as refractory aggregate and CAC as hydraulic binder, with a spinel as an additive. The authors investigated the dehydration reactions which occur from ...