Search
Now showing items 1-10 of 42
The influence of the raw material grinding fineness on the brick industry products quality
(Trans Tech Publications Ltd, Durnten-Zurich, 2002)
The brick industry development trends have two main directions: high product quality and use of lower quality clays and secondary (recycled) raw materials, The development trends reflect today's market requirements - ...
Impact of choice of stabilized hysteresis loop on the end result of investigation of high-strength low-alloy (HSLA) steel on low cycle fatigue
(Croatian Metallurgical Soc, Zagreb, 2014)
High strength low-alloy steel under low cycle fatigue at a certain level of strain controlled achieve stabilized condition. During the fatigue loading stabilized hysteresis loop is determined, which typical cycle of ...
Anionic clay and hydrotalcite synthesis
(Trans Tech Publications Ltd, Durnten-Zurich, 2002)
Anionic clays are becoming more important for their application as catalysts, ion exchangers and adsorbers and for medical applications as well. Anionic clays are also used as stabilizers of dispersive systems of ceramic ...
Correlation among sintering process, porosity, and creep deformation of refractory concrete
(Springer, New York, 2009)
The aim of this paper is to establish the correlation among sintering process, porosity, and important thermo-mechanical property of refractory concrete, i.e., creep. Creep deformation was investigated according to the ...
Quantitative Formulation of Mechanism of Sintering Process during Creep Deformation of Refractory Concretes
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2009)
This paper is concerned with quantitative formulation of the mechanism of the sintering process during secondary state creep deformation of refractory concretes. Investigated concretes varied in, both, chemical and ...
Possibilities of producing solid bricks from mixtures of plastic brick clay and fly ash
(Trans Tech Publications Ltd, Durnten-Zurich, 2004)
The paper briefly reviews results of laboratory testing performed in order to establish the possibility of adopting the process of production of solid bricks from plastic clay and fly ash. The experimental results substantiated ...
Preparation of flish sediments and their application in brick products manufacturing
(Trans Tech Publications Ltd, Durnten-Zurich, 2004)
Flish sediments represent atypical raw materials: marls, marly shales and shales. This paper presents the results of laboratory tests of shales. The paper points out the similarities and differences in technological ...
Static and impact crack properties of a high-strength steel welded joint
(Elsevier Sci Ltd, Oxford, 2007)
in order to gain the benefits of weldable high-strength steels in pressurized equipment applications, satisfactory toughness and crack properties of the welded joint, both in the weld metal and the heat-affected-zone (HAZ), ...
Wire fence as applique armour
(Elsevier Sci Ltd, Oxford, 2010)
In this paper, the behaviour of wire fence was investigated for potential as applique armour. The wire fence used was made from commercial high-strength patented wire and the supporting frames were made of mild steel ...
Failure analysis of the end eye connection of the bucket wheel excavator portal tie-rod support
(Pergamon-Elsevier Science Ltd, Oxford, 2009)
This paper describes the failure analysis results of the bucket wheel excavator (BWE) portal tie-rod support. The results of finite elements analysis (FEA) point out the occurrence of pronounced stress concentration, whereby ...