Претраживање
Приказ резултата 91-100 од 358
On biomimetics in machine elements design
(Manipal University Jaipur, India, 2019)
The aim of the paper is to point up the possibilities of biomimetics principles in the machine elements design. During last decades, the new requirements in machine elements design are placed in front of the experts. The ...
Experimental determination and numerical validation of the critical value of the J-integral ofa low carbon microalloyed steel for elevated temperature application
(VIII INTERNATIONAL CONGRESS ENGINEERING, ENVIRONMENT AND MATERIALS IN PROCESS INDUSTRY EEM 2023, 2023)
To evaluate the behavior of a homogeneous material in the presence of a crack-type defect, the
value of the critical stress-intensity factor, KIc, was determined as a measure of the fracture
toughness of the tested steel ...
Gas cylinder rupture induced by local corrosion damage
(Society for Structural Integrity and Life – Prof. Dr Stojan Sedmak (DIVK), 2018)
Commercial gas cylinders are common type of pressure vessels in many health care and technical facilities. Unexpected
failures of gas cylinders occur despite of fact that the design, manufacture route, quality control, ...
Failure analysis of beam of unmanned aerial vehicle
(University of Belgrade - Faculty of Mechanical Engineering, Belgrade, Serbia, 2022)
The high level of worthiness of unmanned aerial vehicles (UAV), particularly in everyday life, is something that will be common thing in close future. The design solutions for UAV us subject of constant innovation, focused ...
Simulation of the kinematic hardening of AISI 316 steel by nonlinear finite element analysis
(Serbian Society of Mechanics and Faculty of Technical Sciences Novi Sad, Serbia, 2015)
The coupled non-linear transient calculation is performed and explained in order to simulate the kinematic hardening behavior of AISI 316 steel and the Finite Element Method (FEM) is used for presented simulation. The ...
Neural network model for the condition assessment of hydro turbines
(University of Belgrade - Faculty of Mechanical Engineering, Belgrade, Serbia, 2022)
During regular operation, hydro turbine elements have complex operating conditions. In order to prevent major failures, among other common preventive measures, it is necessary to make a useful model of hydro turbine. ...
Theory of critical distances in analysis of the influence of tooth profile on gears bending capacity
(5th International Conference on Power Transmission BAPT2016, 2016)
The fatigue cracks and failures in tooth roots are still one of the most common problems in gear pairs operation.
Therefore, the application of new methods and up-to-date calculation procedures is welcome. This paper ...
Analysis of Hertz contact stresses for metallic material with carbides
(8th International Congress of Serbian Society of Mechanics, Kragujevac, Serbia, 2021)
Hertz contact and the resulting stress-strain state arising from the contact between two elastic solids have practical application in hardness testing, wear and impact damage of engineering ceramics, the design of dental ...
Modal analysis of the hydro turbine shaft with cracks
(Abstracts of 14th International conference Dynamical Systems - Theory and Applications, 2017)
The design process for the elements which are the parts of the structures and equipment in power industry includes both of stress and strain state calculations, as well as an analysis of natural mode shapes and frequencies. ...
Geometric optimization of shaft transition zone based on stress-strain analysis of nature inspired design
(8th International Congress of Serbian Society of Mechanics, Kragujevac, Serbia, 2021)
The presented research primarily considers with the geometric solutions that Nature has optimized. In the study presented in this paper, the nature inspired transition shapes are used in the research of innovative design ...