Претраживање
Приказ резултата 91-100 од 227
Influence of defects on limit loads and integrity of the pipeline at hydropower plant 'Pirot'
(Institut za ispitivanje materijala, Beograd, 2020)
Topic of this work is the integrity assessment of the pipeline section from hydropower plant Pirot. Crack-like defect size, maximum depth, is determined based on non-destructive evaluation - the largest crack depth is taken ...
Determination of ventilation heat losses through building envelope – a case study
(University of Banja Luka Faculty of Architecture, Civil Engineering and Geodesy, 2022)
In this paper the experimental procedure for the determination of ventilation heat losses across building envelopes has been shown. The alternative name for this method is Blower Door Test or Fan Pressurization method. ...
Estimation of the drying behaviour for different clay raw materials - drying sensitivity techniques review Epitoanyang 2022
(Epitőanyag – Journal of Silicate Based and Composite Materials, 2022)
In order to rate the drying behavior of different clay raw materials it is necessary to establish
the criteria for comparison. Mineralogical composition, clay minerals content, particle size
distribution, packing, porosity, ...
The role of drainage systems in the prevention of material degradation of bridge structures
(XXIII YuCorr, Divčibare, Serbia, 2022)
The paper gives an illustrative presentation of damage to the material of bridge structures
due to failure to maintain the system for drainage of bridges. Damage is caused by mechanical
erosion and abrasion or by chemical ...
Application of Artificial Neural Networks in Performance Prediction of Cement Mortars with Various Mineral Additives
(Science of Sintering, 2023)
The machine learning technique for prediction and optimization of building material performances became an essential feature in the contemporary civil engineering. The Artificial Neural Network (ANN) prognosis of mortar ...
The effects of alloying elements on mechanical properties of NIOMOL 490K steel
(Twentieth Young Researchers’ Conference - Materials Science and Engineering: Programme and the Book of Abstracts, 2022)
This paper is to study the effect of alloying elements on mechanical properties of highstrength
low-alloy steel, NIOMOL 490K. This steel grade belongs to the class of
molybdenum microalloyed steels, in which microalloying ...
Application of coal combustion byproducts in self-compacting concrete: influence on flowability
(University of Belgrade, Technical Faculty in Bor, 2023)
Compared to traditional concrete, self-compacting concrete (SCC) demonstrates greater flowability, which is achieved by including an extra high percentage of ultra-fine particles. As a result, the required high paste content ...
Optimize, upgrade or invest in novel dryer? – A brick factory case study
(International Journal of Manufacturing Economics and Management, 2021)
Drying has an enormous impact on the quality of final masonry clay elements. The accumulated knowledge about modeling the drying process, as well as the registered progress in computing the coupling between the heat and ...
Energy dispersive X-ray fluorescence in the investigation of the composition of historical mortars
(1st International Conference with Workshop, Science for Conservation of the Danube Limes Mortar Design for Conservation – Danube Roman Frontier 2000 Years After, Viminacium, Serbia, 2022)