Претраживање
Приказ резултата 11-20 од 58
Update of the procedure used for heavy clay dryer optimization
(Serban Solacolu Foundation, Bucurest, 2018)
The description of the moisture transfer in porous media during drying was the subject of many scientific studies. The unique drying theory was developed five years ago and has recently won a general recognition in the ...
Effects of operation temperature on thermal expansion and main parameters of radial ball bearings
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2015)
The research of influence of operation temperature on the thermal expansion and main parameters of radial ball bearings is presented in this paper. The main bearing parameters are identified in accordance with the increasing ...
Concrete mix design for reconstruction of northwest breakwater in the Tripoli harbour - Libya
(Faculty of Mechanical Engineering in Slavonski Brod, Faculty of Electrical Engineering in Osijek, Faculty of Civil Engineering in Osijek, 2011)
Reconstruction of Northwest breakwater in the Tripoli Harbour - Libya (about 4500 m long) required manufacture of various concrete elements (cubes and accropodes) in total amount of 550 000 m(3). Volumes of cubes were 6,3 ...
Mechanical properties of ultra high performance self compacting concrete with different mineral admixtures
(Revista Romana de Materiale/ Romanian Journal of Materials, 2011)
Preparation and microstructure of ultra high performance concrete (UHPC) have been intensively analyzed In the last few years. The mechanical properties (compressive strength and flexural strength) were investigated under ...
Determination of recycled aggregate concrete degradation by resonance frequency analysis
(Revista Romana de Materiale/ Romanian Journal of Materials, 2011)
The evaluation of the dynamic modulus of elasticity of twelve different concrete mix proportions as a function of the density and degradations due to freeze/thaw cycles is presented in this paper. Pore system and saturation ...
Analysis of the nominal load effects on gear load capacity using the finite-element method
(Sage Publications Ltd, London, 2010)
This research investigates the effects of the nominal load value on load distribution of simultaneously meshing gear teeth pairs, and on the involute gear load capacity. The research results presented in this article confirm ...
Thermal, Ceramic and Technological Properties of Clays used in Production of Roofing Tiles - Principal Component Analysis
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2018)
This research describes a study of 11 selected samples of brick clays applied in roofing tile production, by using simultaneous thermal analysis. Additionally, the laboratory-sized samples were prepared and fired (850-950 ...
Prompt system redesign: Shifting to open source technology to satisfy user requirements
(ComSIS Consortium, 2010)
The paper describes a redesign project undertaken in a short period to adapt a software system to user needs. Additional goals of the project included a shift to Open Source software and the selection of technology to ...
Microstructural analysis as the indicator for suitability of weld repairing of the heat resistant Cr - Ni steel
(Consejo Superior Investigaciones Cientificas-Csic, Madrid, 2010)
Metallurgical evaluation was performed on a fractured column tube of the reformer furnace in an ammonia plant. The tubes were manufactured from centrifugally cast heat resistant steel HK 40. Optical and scanning electron ...
Transport and storage of heavy metals in the Sava River Basin in Serbia
(Srpsko hemijsko društvo, Beograd, 2014)
Selected heavy metals (Cu, Zn, Pb and Cd) in the water and sediment of the Sava River in Serbia were investigated from three locations in the vicinity of industrial and urban settlements (Sabac, Obrenovac and Belgrade) ...