Претраживање
Приказ резултата 111-116 од 116
Effect of temperature and specimen orientation on Charpy impact toughness
(Elsevier, 2022)
Steel grade 14MoV6 3 is used for manufacturing of boilers and steam pipelines designed for steam temperatures up to 560°C. This paper presents the experimental analysis which included impact toughness test. The analysis ...
Lamellar Tearing of Parent Material and Degradation of Welded Joints at Vital Welded Structures
(Savez energetičara, 2021)
Vertical Kaplan turbines, manufactured in Russia, are
installed in 6 hydroelectric generating units at ‘Djerdap 1’, with
nominal power of 176 MW each. Because of the structural
solution and inability of performing ...
Repair of shaft and ventilation ring vanes damages of the generator of the hydroelectric generating set at the hydro power plant
(Savez energetičara, 2020)
Hydro power plant ’Pirot’, which was built in 1990, is
an accumulation-derivative power plant, which consists of 2
above-ground vertical hydroelectric generating sets that contain
Francis turbines with nominal power of ...
Strength of the Welded Joint with Improved Mechanical Properties of Weld Metal and Heat Affected Zone
(Faculty of Mechanical and Civil Engineering in Kraljevo, Serbia, 2021)
Selection of steel, dimensions and fabrication technology for the welded structure are all parts of the design
process, because they are in close connection with the function of the structural whole under certain conditions ...
Damages That Occur at Vital Components of the Thermal Power Plant System Detected by NDT Testing
(Međunarodno savetovanje Energetika, Zlatibor, 2022)
Continuous exploitation in very harsh environmental conditions can lead to relatively frequent damages of steam line system. High place among the causes of these damages takes inadequate exploitation and maintenance. This ...
Numerical simulation of 14Mov6-3 steel CT-specimen Fracture Behavior
(Elsevier B.V., 2022)
Steel grade 14MoV6 3 is used for manufacturing of boilers and steam pipelines designed for steam temperatures up to 560°C. This paper presents the numerical simulation of a CT-specimen, using the finite element method. The ...