Претраживање
Приказ резултата 351-360 од 375
Probabilistic Analysis of Bearing Capacity of Piles with Variable Parameters of CPT Test and Calculation According to the EN 1997-1: 2004
(GNP 2016, Civil Engineering – Science and Practice, International Conference, Žabljak, Montenegro, 2016)
A probabilistic concept for determining pile bearing capacity is presented, taking into account the variability of CPT test parameters and methodology of calculation according to the requirements of Eurocode 7 (EN 1997-1: ...
The analysis of supporting structure of planetary gear box satellite
(Kluwer Academic Publishers, 2006)
Influence of Si content and cooling rates on the size of SDAS and the latent heat released in Al-Si(5-11)-Cu1 alloys
(Proceedings - European Metallurgical Conference, EMC 2007, 2007)
The latent heat of solidification of any alloy depends on the chemistry and the microstructure developed during solidification process. Effects of chemistry on the release of the latent heat during solidification and ...
Welded joints behaviour in service with special reference to pressure equipment
(Springer, Dordrecht, 2009)
Quality and structural integrity of welded pressure equipment are defined by The Pressure Equipment Directive (97/23/EC). The problem is complex, due to welded joint imperfections, matching effect, heterogeneity of ...
Characterization of drying behavior and modeling of industrial drying process
(IOP Publishing Ltd, Bristol, 2020)
The general method for industrial chamber dryer optimization was reported in this paper. The first step in finding the most suitable drying regime is to characterized the clay raw material, especially its water loss at ...
Some experience of concrete design in marine structures
(Thomas Telford Services Ltd, 2005)
For reconstruction of northwest breakwater in Tripoli harbour / Libya, about 4500 m long, it is necessary to produce various concrete elements (cubes and accropodes) in total amount of 550000 m 3 . Volumes of cubes are ...
Sulphur concrete
(Structural Engineering Conferences, SECON, 2007)
Sulphur concrete is a relatively new material, and although similar in final appearance to portland cement concrete, its manufacture, handling, use, and testing are different. Sulphur concrete is a thermoplastic material ...
Analysis of current state and integrity evaluation for the supply tank of generation unit 6 of thermal power plant Nikola Tesla ”A”, Obrenovac
(Trans Tech Publications Ltd, 2014)
Stable supply tank, with volume V = 250 m3 and operating pressure p = 1,5 MPa, of generation unit 6 at thermal power plant 'Nikola Tesla A' in Obrenovac, is designed for water-steam working fluid. It was made of steel Č ...
Investigation of the Repair Welding Technology Using Ni Base Electrode
(Trans Tech Publications Ltd, Durnten-Zurich, 2013)
Metal materials are subjected to innumerable time-dependent degradation mechanisms when operate in power, petrochemical and refinery plant. These materials are subjected to multiaxial stresses, creep, fatigue, corrosion ...
Methodology for reparation of damaged sleeves and welded shield sections of guide vanes at hydropower plant DJERDAP 1
(Trans Tech Publications Ltd, 2014)
Vertical Kaplan turbines, manufactured in Russia and with nominal power of 200 MW, have been installed in 6 hydroelectric generating units at ’Djerdap 1’. During the refurbishment of hydropower plant experimental non-destructive ...