Претраживање
Приказ резултата 11-20 од 23
The possibility of substitution of wear resistant low chromium white iron resistant with basalt melt
(Editura Stiintifica Fmr, Bucharest, 2012)
In this study the testing results of the possibility of substituting mill lining plates for ore milling made of low chromium white iron that is resistant to wear with plates made of basalt melt are presented. Plates made ...
Future Armoured Troop Carrying Vehicles
(Defence Scientific Information Documentation Centre, Delhi, 2010)
Present-day reliance on wheeled and tracked armour personnel carriers (APCs) and infantry fighting vehicles (IFVs), may be changed in the future. Shaped charge grenades and impovised explosive devices (IEDs) represent a ...
Durability of concrete with different types of cement
(Procema SA, 2016)
Adequate measures must be taken during the determination of the concrete composition for ensuring the durability of concrete exposed to an aggressive environment. The influence of the cement type on the freeze/thaw resistance ...
Structural Integrity Assessment of Welded Pressure Vessel Produced of HSLA Steel
(Journal Iron Steel Research Editorial Board, Beijing, 2011)
Welded joint is a critical region of a welded structure. The operational safety of welded pressure equipment mostly depends on the behaviour of loaded weldments. Safety of welded structure is dependent on the properties ...
The influence of silica fume and curing regime on some properties of concrete
(Revista Romana de Materiale/ Romanian Journal of Materials, 2014)
The investigation of posibilities of concrete structure modification by silica fume to improve concrete properties was presented in this report. Percentage of silica fume in regard to cement varied between 0% and 20%. ...
Life extension of gears flank surfaces regenerated by hard facing
(Editura Stiintifica Fmr, Bucharest, 2013)
This paper contains the results of experimental analysis of fatigue endurance of used steel teeth regenerated by hard facing. The cylindrical spur gears were tested and compared with the newly made ones, oiler being ...
Investigation of high temperature behavior and sintering mechanism of fly ash based concretes
(Procema SA, 2014)
Four types of refractory concretes were studied at various temperatures ranging from ambient to adopted maximal 1400 degrees C. The concretes had same matrix composition: K concretes were based on corundum aggregate; B ...
Mechanical properties of ultra high performance self compacting concrete with different mineral admixtures
(Revista Romana de Materiale/ Romanian Journal of Materials, 2011)
Preparation and microstructure of ultra high performance concrete (UHPC) have been intensively analyzed In the last few years. The mechanical properties (compressive strength and flexural strength) were investigated under ...
Determination of recycled aggregate concrete degradation by resonance frequency analysis
(Revista Romana de Materiale/ Romanian Journal of Materials, 2011)
The evaluation of the dynamic modulus of elasticity of twelve different concrete mix proportions as a function of the density and degradations due to freeze/thaw cycles is presented in this paper. Pore system and saturation ...
Characterisation of high-carbon steel surface welded layer
(Strojniski Vestnik/Journal of Mechanical Engineering, 2010)
In this paper microstructural and mechanical properties of high-carbon steel surface welded layer, obtained with self-shielded flux cored wire, are presented in the case of a standard rails and crossings. The testing results ...