Search
Now showing items 21-30 of 42
Identification of low cycle fatigue parameters of high strength low-alloy (HSLA) steel at room temperature
(Croatian Metallurgical Soc, Zagreb, 2014)
Low cycle fatigue test was performed in ambient atmosphere at room temperature. cycle loading of material, in case of High strength low-alloy steel, entails modifications of its properties and in this paper is therefore ...
An Artificial Neural Network-based Prediction Model for Utilization of Coal Ash in Production of Fired Clay Bricks: A review
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2021)
This study analyzed the last 20 years' data available on power plant coal ashes used in clay brick production. The statistical analysis has been carried out for a total of 302 cases based on the relevant parameters reported ...
Performances of Vermiculite and Perlite Based Thermal Insulation Lightweight Concretes
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2020)
This experimental study was conducted with an aim to investigate the effect of the elevated temperature on the mineral phase composition, microstructure and mechanical properties of the thermal insulation lightweight ...
Evaluation of Lignite Fly Ash for Utilization as Component in Construction Materials
(Taylor & Francis Inc, Philadelphia, 2013)
Utilization potential of fly ash, as the main residue in the lignite coal combustion in Serbian power plants, was investigated in present study. High production of fly ash represents extreme hazard for environment. Question ...
Investigation of thermally induced processes in corundum refractory concretes with addition of fly ash
(Springer, Dordrecht, 2015)
The effects that the fly ash addition has on the behavior of thermally resistant corundum concrete were discussed. Experimental program implied production of two refractory composites: "referent" concrete from 20 % of ...
Synthesis and characterization of new refractory coatings based on talc, cordierite, zircon and mullite fillers for lost foam casting process
(Polska Akad Nauk, Polish Acad Sciences, Inst Metall & Mater Sci Pas, Warszawa, 2014)
Refractory coatings based on different refractory fillers (talc, cordierite, zircon and mullite) for application in Lost Foam casting process were investigated. Design and optimization of the coatings composition with ...
A Kinetic Study of Limestone Dry Micronization in an Ultra-Centrifugal Mill with Peripheral Comminuting Path
(Goller Verlag Gmbh, Baden Baden, 2017)
Because of its physico-mechanical and physico-chemical characteristics, fine-ground (i.e. micronized) limestone is widely applied in the production of new materials. Limestone can be used as a filler, coating and/or powder ...
The influence of the raw material grinding fineness on the brick industry products quality
(Trans Tech Publications Ltd, Durnten-Zurich, 2002)
The brick industry development trends have two main directions: high product quality and use of lower quality clays and secondary (recycled) raw materials, The development trends reflect today's market requirements - ...
Impact of choice of stabilized hysteresis loop on the end result of investigation of high-strength low-alloy (HSLA) steel on low cycle fatigue
(Croatian Metallurgical Soc, Zagreb, 2014)
High strength low-alloy steel under low cycle fatigue at a certain level of strain controlled achieve stabilized condition. During the fatigue loading stabilized hysteresis loop is determined, which typical cycle of ...
Preparation of flish sediments and their application in brick products manufacturing
(Trans Tech Publications Ltd, Durnten-Zurich, 2004)
Flish sediments represent atypical raw materials: marls, marly shales and shales. This paper presents the results of laboratory tests of shales. The paper points out the similarities and differences in technological ...