Претраживање
Приказ резултата 111-120 од 131
Prediction model based on artificial neural network for pyrophyllite mechano-chemical activation as an integral step in production of cement binders
(Elsevier Sci Ltd, Oxford, 2020)
The optimal outputs of pyrophyllite mechano-chemical activation in an ultra-centrifugal mill performing under different technological conditions were determined by analytical modeling and verified via Artificial Neural ...
An Artificial Neural Network-based Prediction Model for Utilization of Coal Ash in Production of Fired Clay Bricks: A review
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2021)
This study analyzed the last 20 years' data available on power plant coal ashes used in clay brick production. The statistical analysis has been carried out for a total of 302 cases based on the relevant parameters reported ...
Performances of Vermiculite and Perlite Based Thermal Insulation Lightweight Concretes
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2020)
This experimental study was conducted with an aim to investigate the effect of the elevated temperature on the mineral phase composition, microstructure and mechanical properties of the thermal insulation lightweight ...
Optimization of adobe clay bricks based on the raw material properties (mathematical analysis)
(Elsevier Sci Ltd, Oxford, 2020)
This research studies the effects of composition and granulometry analysis of 139 heavy clays on the important characteristics of wet and adobe clay bricks. ANN models were obtained with high prediction accuracy in training ...
Numerical determination and experimental validation of the fracture toughness of welded joints
(Pergamon-Elsevier Science Ltd, Oxford, 2020)
Most of the serious weldment failures lead to catastrophic consequences in terms of damage of other equipment, loss of production, and risks to workers' health and safety. Hence, there is motivation to find margin between ...
Characterization of drying behavior and modeling of industrial drying process
(IOP Publishing Ltd, Bristol, 2020)
The general method for industrial chamber dryer optimization was reported in this paper. The first step in finding the most suitable drying regime is to characterized the clay raw material, especially its water loss at ...
Has the latest global financial crisis changed the way road public-private partnerships are funded? A comparison of Europe and Latin America
(Elsevier Sci Ltd, Oxford, 2020)
A financial/economic crisis may have an adverse effect on transport public-private partnerships (PPPs) as both traffic demand is negatively influenced, and governments are further under pressure. However, research on awarded ...
Assessment of Grain Size and Grain Refinement Efficiency by Calculation of Released Heat Attributed to Formation of Primary Aluminum Crystals During Solidification of Al7Si4Cu Alloy
(Springer India, New Delhi, 2021)
Assessing heat released only related to the formation of primary crystals provides results with a significantly higher sensitivity than a traditional assessment of undercooling value. In this work, two similar Ti5B1 master ...
The characterization and pollution status of the surface sediment in the Boka Kotorska Bay, Montenegro
(Springer Heidelberg, Heidelberg, 2021)
Surface sediments collected from twelve stations in the Boka Kotorska Bay were analyzed for the level and distribution of twenty-six elements and ten oxides, grain sizes, organic matter, and carbonate content. Potentially ...
Improvement and modification of the energy-dispersive X-ray fluorescence method for the determination of metal elements in cement leachates - A chemometric approach
(Srpsko hemijsko društvo, Beograd, 2020)
A modification of an analytical procedure for the energy-dispersive X-ray fluorescence (EDXRF) quantification of ten chemical elements (As, Ba, Cd, Co, Cr, Cu, Mo, Ni, Pb and Zn) in the leachates obtained from cement binders ...