Претраживање
Приказ резултата 11-20 од 70
Effects of operation temperature on thermal expansion and main parameters of radial ball bearings
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2015)
The research of influence of operation temperature on the thermal expansion and main parameters of radial ball bearings is presented in this paper. The main bearing parameters are identified in accordance with the increasing ...
Thermal, Ceramic and Technological Properties of Clays used in Production of Roofing Tiles - Principal Component Analysis
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2018)
This research describes a study of 11 selected samples of brick clays applied in roofing tile production, by using simultaneous thermal analysis. Additionally, the laboratory-sized samples were prepared and fired (850-950 ...
Physical-Mechanical Properties of Cement Stabilized RAP/Crushed Stone Aggregate Mixtures
(Univ Osijek, Tech Fac, Slavonski Brod, 2019)
The paper presents and analyzes the results of testing the properties of cement stabilized mixtures of reclaimed asphalt pavement (RAP) and crushed stone aggregate (CSA). Tests were carried out on reclaimed asphalt pavement ...
Characterisation of high-carbon steel surface welded layer
(Strojniski Vestnik/Journal of Mechanical Engineering, 2010)
In this paper microstructural and mechanical properties of high-carbon steel surface welded layer, obtained with self-shielded flux cored wire, are presented in the case of a standard rails and crossings. The testing results ...
Uticaj geometrije trna alata na mehaničke i strukturne karakteristike sučeonog spoja aluminijumske legure 2024-T351 zavarenog postupkom FSW / Influence of pin geometry on mechanical and structural properties of butt friction stir welded 2024-T351 aluminum alloy
(Savez hemijskih inženjera, Beograd, 2015)
U radu je ispitivano kakav zajednički, kombinovani uticaj brzina rotacije alata, brzina zavarivanja i mala promena u geometriji trna alata imaju na zavarljivost, mehaničke i strukturne karakteristike sučeonog spoja Al ...
Effect of welded joint imperfection on the integrity of pipe elbows subjected to internal pressure
(Faculty of Mechanical Engineering in Slavonski Brod, Faculty of Electrical Engineering in Osijek, Faculty of Civil Engineering in Osijek, 2013)
Since local defects reduce the load-carrying capacity and deformation ability of a piping system, an analysis is undertaken to quantify the influence of weld defects on integrity of the pipe elbows subjected to internal ...
Classification tools based on artificial neural networks for the purpose of identification of origin of organic matter and oil pollution in recent sediments
(TU Munchen, 1998)
The distinction between autochthonous, and oil-like origin of organic matter in geological sediments can be performed on the basis of n-alkane abundance and distribution patterns, determined by gas chromatography, or on ...
Influence of mineralizers on mullite synthesis
(American Ceramic Society, 2006)
Prompt system redesign: Shifting to open source technology to satisfy user requirements
(ComSIS Consortium, 2010)
The paper describes a redesign project undertaken in a short period to adapt a software system to user needs. Additional goals of the project included a shift to Open Source software and the selection of technology to ...
Microstructural analysis as the indicator for suitability of weld repairing of the heat resistant Cr - Ni steel
(Consejo Superior Investigaciones Cientificas-Csic, Madrid, 2010)
Metallurgical evaluation was performed on a fractured column tube of the reformer furnace in an ammonia plant. The tubes were manufactured from centrifugally cast heat resistant steel HK 40. Optical and scanning electron ...