Претраживање
Приказ резултата 21-30 од 363
Some experience of concrete design in marine structures
(Thomas Telford Services Ltd, 2005)
For reconstruction of northwest breakwater in Tripoli harbour / Libya, about 4500 m long, it is necessary to produce various concrete elements (cubes and accropodes) in total amount of 550000 m 3 . Volumes of cubes are ...
Sulphur concrete
(Structural Engineering Conferences, SECON, 2007)
Sulphur concrete is a relatively new material, and although similar in final appearance to portland cement concrete, its manufacture, handling, use, and testing are different. Sulphur concrete is a thermoplastic material ...
The possibility of obtaining. Composite al18wt%si/sic by compocasting process
(ModTech Publishing House, 2012)
The aim of this study was to investigate the influence of various process parameters on the microstructure of composite materials based on alloys All 8Wt%Si with the addition of 10Wt%SiC. The effect of stirring speed (1000 ...
HSLA Steel - Simulation of Fatigue
(Springer, 2020)
In present paper, based on the results of the experimental study of the behaviour of the samples made of a HSLA steel, in the form of round smooth specimens (RSS) under LCF conditions (with controlled and completely ...
Compressive Strength Improvements of Cement-Based Composites Achieved with Additional Milling of Metakaolin
(Springer, Dordrecht, 2018)
Kaolin from a Serbian deposit, having a high content of mica and quartz, disordered kaolinite and a high specific surface area, was used to prepare metakaolin (MK). The calcination at temperatures of 700 degrees C or 750 ...
Properties of the Cement-Based Composites with High Content of Metakaolin
(Springer, Dordrecht, 2018)
Environmental concerns and sustainable development require increased replacement of cement. Most of previous studies have shown that the compressive strength of cement-based composites is maximized with a 20% content of ...
Low cycle fatigue of weldments produced of a high strength low alloyed steel
(Elsevier Science Bv, Amsterdam, 2014)
A quenched and tempered high strength low alloy steel NIONIKRAL 70 for producing welded pressure vessels, where high resistance to fatigue crack propagation and high tolerance of damage are of high importance, has been ...
Analysis of current state and integrity evaluation for the supply tank of generation unit 6 of thermal power plant Nikola Tesla ”A”, Obrenovac
(Trans Tech Publications Ltd, 2014)
Stable supply tank, with volume V = 250 m3 and operating pressure p = 1,5 MPa, of generation unit 6 at thermal power plant 'Nikola Tesla A' in Obrenovac, is designed for water-steam working fluid. It was made of steel Č ...
Investigation of the Repair Welding Technology Using Ni Base Electrode
(Trans Tech Publications Ltd, Durnten-Zurich, 2013)
Metal materials are subjected to innumerable time-dependent degradation mechanisms when operate in power, petrochemical and refinery plant. These materials are subjected to multiaxial stresses, creep, fatigue, corrosion ...
Methodology for reparation of damaged sleeves and welded shield sections of guide vanes at hydropower plant DJERDAP 1
(Trans Tech Publications Ltd, 2014)
Vertical Kaplan turbines, manufactured in Russia and with nominal power of 200 MW, have been installed in 6 hydroelectric generating units at ’Djerdap 1’. During the refurbishment of hydropower plant experimental non-destructive ...