Претраживање
Приказ резултата 1-10 од 138
Establishing a method for determination of effective diffusion coefficiente
(ModTech Publishing House, 2011)
The aim of this paper is to calculate the effective diffusion coefficient for typical masonry clay on the base of experimentally recorded drying curves. Two computer programs for calculation of diffusion coefficient, which ...
Determination of Residual Fatigue Life of Welded Structures at Bucket-Wheel Excavators through the Use of Fracture Mechanics
(Elsevier Science Bv, Amsterdam, 2018)
This paper presents a methodological approach for the assessment of service life of vital welded structures of a bucket-wheel excavator Sch Rs 650/5x24 ('Thyssen Krupp', Germany) boom, subjected to cyclic loading with a ...
Analysis of current state and integrity evaluation for the supply tank of generation unit 6 of thermal power plant Nikola Tesla ”A”, Obrenovac
(Trans Tech Publications Ltd, 2014)
Stable supply tank, with volume V = 250 m3 and operating pressure p = 1,5 MPa, of generation unit 6 at thermal power plant 'Nikola Tesla A' in Obrenovac, is designed for water-steam working fluid. It was made of steel Č ...
Investigation of the Repair Welding Technology Using Ni Base Electrode
(Trans Tech Publications Ltd, Durnten-Zurich, 2013)
Metal materials are subjected to innumerable time-dependent degradation mechanisms when operate in power, petrochemical and refinery plant. These materials are subjected to multiaxial stresses, creep, fatigue, corrosion ...
Methodology for reparation of damaged sleeves and welded shield sections of guide vanes at hydropower plant DJERDAP 1
(Trans Tech Publications Ltd, 2014)
Vertical Kaplan turbines, manufactured in Russia and with nominal power of 200 MW, have been installed in 6 hydroelectric generating units at ’Djerdap 1’. During the refurbishment of hydropower plant experimental non-destructive ...
The possibility of obtaining. Composite al18wt%si/sic by compocasting process
(ModTech Publishing House, 2012)
The aim of this study was to investigate the influence of various process parameters on the microstructure of composite materials based on alloys All 8Wt%Si with the addition of 10Wt%SiC. The effect of stirring speed (1000 ...
Effect of changes in matric suction on slope stability in natural unsaturated soil
(ICE Publishing, 2015)
Stability analyses were performed for a real engineering-geological cross-section of unsaturated Quaternary silt sediments. Unsaturated shear strength is a function of the two stress variables: net normal stress and matric ...
Experimental and numerical investigations of the critical values of J-integral for the steel of steam pipelines
(Elsevier Science Bv, Amsterdam, 2018)
Steel grade 14MoV6-3 is a low-carbon microalloyed steel with addition of chromium and molybdenum. This grade is designed mainly for power industry applications, withstanding operating at elevated temperatures.In this paper, ...
Determination of apparent porosity level of refractory concrete using ultrasonic pulse velocity technique and image analysis
(American Ceramic Society, 2011)
Aim of this paper is to establish the correlation between sintering process, porosity and important thermo-mechanical property of refractory concrete, i.e. creep. Creep deformation was investigated according to standard ...
The failures of a supporting structure of a coal-reloading bridge and methodological approach to recovery of the damages
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
In present paper, methodological approach to the analysis of the failures and recovery of the damages has been presented on an example of fracture and damage of a structure of the reloading bridge. The approach presented ...