Претраживање
Приказ резултата 81-90 од 251
Comparative analysis of process parameters of talc mechanical activation in centrifugal and attrition mill
(Oficyna Wydawnicza Politechniki Wroclawskiej, Wroclaw, 2014)
The efficiency of talc mechanical activation by means of two different mechano-activators centrifugal and attrition mill is investigated in this study and the comparative analysis of the characteristics of obtained talc ...
Premazi na bazi cirkona sa primenom u Lost Foam procesu livenja / Zircon-based coating for the applications in Lost Foam casting process
(Savez hemijskih inženjera, Beograd, 2012)
U ovom radu je istraživana mogućnost dobijanja novih vatrostalnih premaza na bazi cirkona koji bi imali primenu u livarstvu. Optimizacija sastava premaza kontrolisana reološkim svojstvima postignuta je primenom različitih ...
Failure of steam line causes determined by NDT testing in power and heating plants
(Gruppo Italiano Frattura, 2013)
This paper examines leakage and damages of steam and provides an overview of NDT testing in order to determine the cause of steam lines failure in power plants and heating plants. This approach may be applied to similar ...
Synthesis, characterization and application of the filler based on corundum for obtaining the ceramic coats in foundry
(Editura Stiintifica Fmr, Bucharest, 2012)
In this work, a possibility to develop new ceramic coats based corundum for casting applications has been examined. Optimization of coating composition with controlled rheological properties was attained by applying different ...
Natural, modified and saturated zeolites as additives in Portland cement
(Bauverlag Bv Gmbh, Gutersloh, 2014)
Optimization of bentonite clay mechano-chemical activation using artificial neural network modeling
(Elsevier Sci Ltd, Oxford, 2017)
The properties of seven montmorillonite-rich bentonites of different geological origin were investigated prior and subsequent to mechano-chemical processing in an ultra-centrifugal mill. The objective of the experiment was ...
Optimization of drying through analytical modeling: clays as bonding agents in refractory materials
(Elsevier Sci Ltd, Oxford, 2016)
The objective of this study was to investigate the clay drying as a unit operation in the refractory materials processing. Two clays that varied in chemical and mineralogical compositions were experimentally tested in a ...
Specific features of stainless steel compression elements
(Croatian Soc Civil Engineers-Hsgi, Zagreb, 2015)
Stainless steel has a number of features that define different behaviour of structural elements made of this material, as related to equivalent carbon steel elements. These properties, especially prominent in case of ...
Microstructure and Phase Composition Of Steatite Ceramics Sintered by Traditional and Spark Plasma Sintering
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2018)
The influence of the sintering method on the mineral phase transformations and development of the crystalline microstructure of steatite ceramics was investigated. The steatite samples were fabricated from talc and bentonite ...
Mechanical Activation as Sintering Pre-treatment of Talc for Steatite Ceramics
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2014)
The effect of vibratory mill induced mechanical activation on the change of the particle size, crystallinity and the phase transformations of the minerals present in the activated material, was studied with the purpose of ...