Претраживање
Приказ резултата 11-20 од 44
Influence of FSW parameters on formation quality and mechanical properties of Al 2024-T351 butt welded joints
(Elsevier, Amsterdam, 2013)
The influence of R/v ratio on joint quality in 2024-T351 aluminum alloy was studied. Specimens were subjected to friction stir welding with the rotation rates of 750, 950 and 1180 r/min and welding speed between 73 and 190 ...
Investigation of the Repair Welding Technology Using Ni Base Electrode
(Trans Tech Publications Ltd, Durnten-Zurich, 2013)
Metal materials are subjected to innumerable time-dependent degradation mechanisms when operate in power, petrochemical and refinery plant. These materials are subjected to multiaxial stresses, creep, fatigue, corrosion ...
A Kinetic Study of Micronization Grinding of Dry Mica in a Planetary Ball Mill
(Hindawi Ltd, London, 2013)
This paper presents results of the research of micronization grinding of dry mica in a planetary ball mill. Investigation was conducted in order to improve the quality and to obtain clearly defined properties and characteristics ...
Procena parametara zbijanosti tla na osnovu Atterbergovih granica konzistencije / Estimation of soil compaction parameters based on the Atterberg limits
(Institut za rudarstvo i metalurgiju, Bor, 2013)
U radu je dat prikaz veze između Atterbergovih granica konzistencije i parametara zbijenosti tla dobijenih korelaciono-regresionom analizom. Veze između granice tečenja wl, granice plastičnosti wp, maksimalne suve gustine ...
Life extension of gears flank surfaces regenerated by hard facing
(Editura Stiintifica Fmr, Bucharest, 2013)
This paper contains the results of experimental analysis of fatigue endurance of used steel teeth regenerated by hard facing. The cylindrical spur gears were tested and compared with the newly made ones, oiler being ...
Failure of steam line causes determined by NDT testing in power and heating plants
(Gruppo Italiano Frattura, 2013)
This paper examines leakage and damages of steam and provides an overview of NDT testing in order to determine the cause of steam lines failure in power plants and heating plants. This approach may be applied to similar ...
Optimization of the production process through response surface method: Bricks made of loess
(Elsevier Sci Ltd, Oxford, 2013)
Loess clays are commonly used to produce bricks. Heavy clays, taken at location near Zrenjanin, Serbia, are used as a representative raw material in this study. The sample, containing about 28% of clay sized particles, is ...
Influence of modifying methods on quality of eutectic and hypereutectic silumine for diesel engine pistons
(Maney Publishing, Leeds, 2013)
The results of the investigation of the influence of different modifiers (sodium, phosphorus, antimony and strontium) on the quality of AlSi12CuMgNi and AlSi18CuMgNi alloys, which are used for the production of pistons, ...
Application of chromite in the production of refractory coatings
(Verlag Schmidt GmbH, 2013)
This work investigated the possibility of developing new chromite-based refractory coatings for hot metal casting applications. The coating composition and rheological properties were optimized by careful choice of binding ...
State Analysis and Integrity of Welded Structures of the Upper Ring of the Turbine Runner Guide Vane Apparatus of Hydroelectric Generating Set A6 on Hydro Power Plant Djerdap 1
(Trans Tech Publications Ltd, Durnten-Zurich, 2013)
During the refurbishment of the hydroelectric generating set A6 on HPP "Djerdap 1", for the state analysis and assessment of the level and causes of degradation of the structure of the vertical Kaplan turbine runner guide ...