Претраживање
Приказ резултата 141-150 од 268
Estimation of temperature transfer function in facade wall heat transport
(Građevinski fakultet Subotica, 2017)
This paper is presenting a method for temperature transfer function (TTF)
estimation by filtering an experimentally collected data. The experimental data were
obtained in simultaneous measurements of inside and outside ...
Composite structural members in fire conditions and measures of protection
(Građevinski fakultet Subotica, 2017)
In this paper, the results of numerical simulation of 2D non-stationary
temperature fields in commonly used composite structural members made of steel and
concrete in fire conditions were presented. Simulation is based ...
Mechanical Properties and Microstructure Fractal Analysis of Refractory Bauxite Concrete
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2015)
The surface topography analysis via fractals as a means of explanation of composite materials mechanical and microstructural characteristics has hardly been reported so far. This study proposes a method of fractal analysis ...
Impact of CO2 Emissions on Low Volume Road Maintenance Policy: Case Study of Serbia
(Sage Publications Inc, Thousand Oaks, 2019)
About 20% of the Serbian national road network has sections with low volume traffic. These sections are maintained in relatively poor condition since the maintenance budget is typically allocated to the road sections with ...
Phytoremediation of agricultural land contaminated with pesticides
(International Conference "Ecological improvement of devastated locations for sustainable development", Conference Proceedings, 2014)
Pesticides are substances intended for preventing, destroying, suppressing or reducing pests.
They are in use for more than 60 years and they are divided according to purpose, chemical
composition and toxicity category. ...
Economical and ecological aspects of use of bio-lubricants and conventional lubricants
(Goriva i maziva, 55, 3, 2016)
It is believed that more than 50% of produced lubricants during or/and after the operation is due directly or indirectly to the environment. For these reasons, in areas where the application of lubricant is related to the ...
Analiza postupka ocenjivanja životnog ciklusa opekarskih proizvoda
(Izgradnja, 2019)
Poznato je da se u proizvodnji opekarskih proizvoda koriste velike količine sirovina koje takođe uključuju visoku potrošnju energije što se negativno odražava na kvalitet životne sredine. Ocenjivanje životnog ciklusa (eng. ...
Comparative analysis of fly ash management in Europe and Serbia: aspects and regulations
(Chymicus IV, 2012)
This paper presents a comparative analysis of the fly ash management in Europe and Serbia, as well as its application the building materials production, with special reference to the existing legislation.
The draft ...
Comparison and evaluation of recently reported methods for optimization of industrial drying regimes
(IOP Publishing Ltd, Bristol, 2018)
In our previous studies we have presented the calculation method along with the procedure for setting up the non isothermal drying regime. Even though this method is harmonized, with the theory of moisture migration during ...