Pretraživanje
Prikaz rezultata 11-20 od 38
Drying kinetic simulation of clay tiles made from the raw material having less clay fraction
(Trans Tech Publications Ltd, 2014)
In order to describe the internal moisture rate and to take all different mechanisms of moisture movement into account, it is suitable to use effective diffusivity as a measure of moisture rate, irrespectively of the ...
Phenomenon of moisture expansion and its influence on mechanical properties of brick clay products
(11th International Conference and Exhibition of the European Ceramic Society 2009, 2009)
The paper considers the moisture expansionphenomenon, as a specific form of corrosion process ofbrick clay products degradation [1]. The influence of themineralogical composition of raw materials, firingtemperature and ...
Welded joints behaviour in service with special reference to pressure equipment
(Springer, Dordrecht, 2009)
Quality and structural integrity of welded pressure equipment are defined by The Pressure Equipment Directive (97/23/EC). The problem is complex, due to welded joint imperfections, matching effect, heterogeneity of ...
An analysis of the influence of weldment heterogeneity in ferrite-austenite welded structure
(Welding in the World, 2009)
An analysis of the influence of heterogeneity of the ferriteaustenite welded joint on its integrity has been performed. The Charpy specimens, with notch positioned in different regions of welded joint, have been tested ...
Linings based chromite for application in foundry
(ModTech Publishing House, 2012)
In this work, a possibility to develop new chromite-based refractory linings for casting applications has been examined. Lining composition optimization with the controlled reologic properties was achieved by applying ...
Analysis of current state and integrity evaluation for the supply tank of generation unit 6 of thermal power plant Nikola Tesla ”A”, Obrenovac
(Trans Tech Publications Ltd, 2014)
Stable supply tank, with volume V = 250 m3 and operating pressure p = 1,5 MPa, of generation unit 6 at thermal power plant 'Nikola Tesla A' in Obrenovac, is designed for water-steam working fluid. It was made of steel Č ...
Investigation of the Repair Welding Technology Using Ni Base Electrode
(Trans Tech Publications Ltd, Durnten-Zurich, 2013)
Metal materials are subjected to innumerable time-dependent degradation mechanisms when operate in power, petrochemical and refinery plant. These materials are subjected to multiaxial stresses, creep, fatigue, corrosion ...
Methodology for reparation of damaged sleeves and welded shield sections of guide vanes at hydropower plant DJERDAP 1
(Trans Tech Publications Ltd, 2014)
Vertical Kaplan turbines, manufactured in Russia and with nominal power of 200 MW, have been installed in 6 hydroelectric generating units at ’Djerdap 1’. During the refurbishment of hydropower plant experimental non-destructive ...
Quantification of stress raiser influence on decrease of machine parts fatigue life
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
This paper displays the usage of Theory of Critical Distances (TCD) in the prediction of high-cycle fatigue behaviour in machine parts and systems. It is possible to gain real overview of stresses of machine parts by Finite ...
The influence of corrosion on stress concentration factor at shaft to flange radius
(Springer Netherlands, 2013)
This paper describes the influence of corrosion on stress concentration factor and crack initiation at shaft-flange transition section. The real turbine shaft failure case study is used for research. This case study and ...