Претраживање
Приказ резултата 141-150 од 864
Determination of apparent porosity level of refractory concrete using ultrasonic pulse velocity technique and image analysis
(American Ceramic Society, 2011)
Aim of this paper is to establish the correlation between sintering process, porosity and important thermo-mechanical property of refractory concrete, i.e. creep. Creep deformation was investigated according to standard ...
HSLA Steel - Simulation of Fatigue
(Springer, 2020)
In present paper, based on the results of the experimental study of the behaviour of the samples made of a HSLA steel, in the form of round smooth specimens (RSS) under LCF conditions (with controlled and completely ...
The failures of a supporting structure of a coal-reloading bridge and methodological approach to recovery of the damages
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
In present paper, methodological approach to the analysis of the failures and recovery of the damages has been presented on an example of fracture and damage of a structure of the reloading bridge. The approach presented ...
Natural, modified and saturated zeolites as additives in Portland cement
(Bauverlag Bv Gmbh, Gutersloh, 2014)
Optimization of bentonite clay mechano-chemical activation using artificial neural network modeling
(Elsevier Sci Ltd, Oxford, 2017)
The properties of seven montmorillonite-rich bentonites of different geological origin were investigated prior and subsequent to mechano-chemical processing in an ultra-centrifugal mill. The objective of the experiment was ...
Optimization of drying through analytical modeling: clays as bonding agents in refractory materials
(Elsevier Sci Ltd, Oxford, 2016)
The objective of this study was to investigate the clay drying as a unit operation in the refractory materials processing. Two clays that varied in chemical and mineralogical compositions were experimentally tested in a ...
Specific features of stainless steel compression elements
(Croatian Soc Civil Engineers-Hsgi, Zagreb, 2015)
Stainless steel has a number of features that define different behaviour of structural elements made of this material, as related to equivalent carbon steel elements. These properties, especially prominent in case of ...
Microstructure and Phase Composition Of Steatite Ceramics Sintered by Traditional and Spark Plasma Sintering
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2018)
The influence of the sintering method on the mineral phase transformations and development of the crystalline microstructure of steatite ceramics was investigated. The steatite samples were fabricated from talc and bentonite ...
Mechanical Activation as Sintering Pre-treatment of Talc for Steatite Ceramics
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2014)
The effect of vibratory mill induced mechanical activation on the change of the particle size, crystallinity and the phase transformations of the minerals present in the activated material, was studied with the purpose of ...
Methodological procedure for selection the type and construction of self-propelled hydraulic support for coal excavation on the example of the coal deposit 'Poljana'
(Institut za rudarstvo i metalurgiju, Bor, 2018)
For the application of a wide forehead method, decisive is an assessment, respectively, selection of the type and construction of self-propelled hydraulic support, both for horizontal and vertical excavation concentrations. ...