Претраживање
Приказ резултата 1-10 од 28
Linings based chromite for application in foundry
(ModTech Publishing House, 2012)
In this work, a possibility to develop new chromite-based refractory linings for casting applications has been examined. Lining composition optimization with the controlled reologic properties was achieved by applying ...
Microstructure analysis and crack detection in turbine blades after prolonged exposure in plant
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
Turbine blades are one of the most important machine parts in every power generator. Corrosion and/or erosion attack on blades are also available in moisture atmosphere, because the wet water vapour is an usual working ...
Review of results of interlaboratory comparisons of national accredited laboratorys in the free field noise level measurements
(IEEE, NEW YORK, 2015)
Interlaboratory comparisons in the field of enviromental noise level measurements were organized by IMS Institute in Belgrade in August this year as a part of the standard noise monitoring according to of the method given ...
Convergence Predictions and Primary Support Optimization of the Tunnel Progon
(Springer Int Publishing Ag, Cham, 2015)
The tunnel Progon is being constructed as a part of Corridor 10 highway project about 5 km north from the border crossing with Bulgaria in southern Serbia. During the design process 2D finite element analysis was utilized ...
Drying kinetic simulation of clay tiles made from the raw material having less clay fraction
(Trans Tech Publications Ltd, 2014)
In order to describe the internal moisture rate and to take all different mechanisms of moisture movement into account, it is suitable to use effective diffusivity as a measure of moisture rate, irrespectively of the ...
Mix design and engineering properties of ultra high performance self compacting concrete
(Czech Concrete Soc-Ceska Betonarska Spolecnost Cssi, Prague 1, 2011)
The mechanical properties (compressive strength and flexural strength) were investigated under different curing conditions (standard and steam curing). Silica fumes have characteristics that make them necessary in cement ...
Analysis of current state and integrity evaluation for the supply tank of generation unit 6 of thermal power plant Nikola Tesla ”A”, Obrenovac
(Trans Tech Publications Ltd, 2014)
Stable supply tank, with volume V = 250 m3 and operating pressure p = 1,5 MPa, of generation unit 6 at thermal power plant 'Nikola Tesla A' in Obrenovac, is designed for water-steam working fluid. It was made of steel Č ...
Investigation of the Repair Welding Technology Using Ni Base Electrode
(Trans Tech Publications Ltd, Durnten-Zurich, 2013)
Metal materials are subjected to innumerable time-dependent degradation mechanisms when operate in power, petrochemical and refinery plant. These materials are subjected to multiaxial stresses, creep, fatigue, corrosion ...
Methodology for reparation of damaged sleeves and welded shield sections of guide vanes at hydropower plant DJERDAP 1
(Trans Tech Publications Ltd, 2014)
Vertical Kaplan turbines, manufactured in Russia and with nominal power of 200 MW, have been installed in 6 hydroelectric generating units at ’Djerdap 1’. During the refurbishment of hydropower plant experimental non-destructive ...
Quantification of stress raiser influence on decrease of machine parts fatigue life
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
This paper displays the usage of Theory of Critical Distances (TCD) in the prediction of high-cycle fatigue behaviour in machine parts and systems. It is possible to gain real overview of stresses of machine parts by Finite ...