Претраживање
Приказ резултата 11-20 од 42
Preparation of flish sediments and their application in brick products manufacturing
(Trans Tech Publications Ltd, Durnten-Zurich, 2004)
Flish sediments represent atypical raw materials: marls, marly shales and shales. This paper presents the results of laboratory tests of shales. The paper points out the similarities and differences in technological ...
Geometry, mechanical properties and mounting of perforated plates for ballistic application
(Elsevier Sci Ltd, Oxford, 2010)
In this paper, the ballistic resistance of perforated plates made of different types of steel, mounting and geometry was investigated. Different types of steel in various heat treatment conditions were tested. Target ...
Wire fence as applique armour
(Elsevier Sci Ltd, Oxford, 2010)
In this paper, the behaviour of wire fence was investigated for potential as applique armour. The wire fence used was made from commercial high-strength patented wire and the supporting frames were made of mild steel ...
Experimental and numerical thermo - mechanical analysis of friction stir welding of high - strength alluminium alloy
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
This paper presents experimental and numerical analysis of the change of temperature and force in the vertical direction during the friction stir welding of high-strength aluminium alloy 2024 T3. This procedure confirmed ...
Correlation among sintering process, porosity, and creep deformation of refractory concrete
(Springer, New York, 2009)
The aim of this paper is to establish the correlation among sintering process, porosity, and important thermo-mechanical property of refractory concrete, i.e., creep. Creep deformation was investigated according to the ...
Possibilities of producing solid bricks from mixtures of plastic brick clay and fly ash
(Trans Tech Publications Ltd, Durnten-Zurich, 2004)
The paper briefly reviews results of laboratory testing performed in order to establish the possibility of adopting the process of production of solid bricks from plastic clay and fly ash. The experimental results substantiated ...
The influence of the raw material grinding fineness on the brick industry products quality
(Trans Tech Publications Ltd, Durnten-Zurich, 2002)
The brick industry development trends have two main directions: high product quality and use of lower quality clays and secondary (recycled) raw materials, The development trends reflect today's market requirements - ...
Impact of choice of stabilized hysteresis loop on the end result of investigation of high-strength low-alloy (HSLA) steel on low cycle fatigue
(Croatian Metallurgical Soc, Zagreb, 2014)
High strength low-alloy steel under low cycle fatigue at a certain level of strain controlled achieve stabilized condition. During the fatigue loading stabilized hysteresis loop is determined, which typical cycle of ...
Synthesis and characterization of new refractory coatings based on talc, cordierite, zircon and mullite fillers for lost foam casting process
(Polska Akad Nauk, Polish Acad Sciences, Inst Metall & Mater Sci Pas, Warszawa, 2014)
Refractory coatings based on different refractory fillers (talc, cordierite, zircon and mullite) for application in Lost Foam casting process were investigated. Design and optimization of the coatings composition with ...
Influence of FSW parameters on formation quality and mechanical properties of Al 2024-T351 butt welded joints
(Elsevier, Amsterdam, 2013)
The influence of R/v ratio on joint quality in 2024-T351 aluminum alloy was studied. Specimens were subjected to friction stir welding with the rotation rates of 750, 950 and 1180 r/min and welding speed between 73 and 190 ...