Pretraživanje
Prikaz rezultata 51-60 od 63
Comparison of refractory coatings based on talc, cordierite, zircon and mullite fillers for lost-foam casting
(Inst Za Kovinske Materiale I In Tehnologie, Ljubjana, 2015)
This study presents the results of an investigation of high-temperature materials refractory coatings based on different refractory fillers including talc, cordierite, zircon and mullite applied in the lost-foam casting ...
Investigation of high temperature behavior and sintering mechanism of fly ash based concretes
(Procema SA, 2014)
Four types of refractory concretes were studied at various temperatures ranging from ambient to adopted maximal 1400 degrees C. The concretes had same matrix composition: K concretes were based on corundum aggregate; B ...
Need to Improve the Natural Aggregate Resources Supply in the City of Belgrade (Serbia)
(Berg Fac Technical Univ Kosice, Kosice, 2016)
The City of Belgrade is the largest market for aggregates in Serbia but the production of natural aggregates is rather small, around five percent of total consumption. This reflects the geology of the City of Belgrade ...
Determination of the apparent porosity level of refractory concrete during a sintering process using an ultrasonic pulse velocity technique and image analysis
(Savez hemijskih inženjera, Beograd, 2010)
Concrete which undergoes a thermal treatment before (pre-casted concrete blocks) and during (concrete embedded in-situ) its life-service can be applied in plants operating at high temperature and as thermal insulation. ...
Dobijanje metakaolina termičkim tretmanom kaolinske gline / Thermal treatment of kaolin clay to obtain metakaolin
(Savez hemijskih inženjera, Beograd, 2010)
U radu su prikazani rezultati istraživanja dobijanja metakaolina termičkim tretmanom domaće kaolinske gline. Polazna sirovina je bila kaolinska glina sa ležišta Vrbica (Aranđelovački basen), čiji je sadržaj kaolinita oko ...
Structural Integrity Assessment of Welded Pressure Vessel Produced of HSLA Steel
(Journal Iron Steel Research Editorial Board, Beijing, 2011)
Welded joint is a critical region of a welded structure. The operational safety of welded pressure equipment mostly depends on the behaviour of loaded weldments. Safety of welded structure is dependent on the properties ...
Activated flux tig welding of stainless-steel pipes
(Savez hemijskih inženjera, Beograd, 2019)
In this work, the presence of TiO2 nanoparticle-based activated flux combined with orbital welding of seamless thick-walled pipes of stainless steel and low-cycle pulse current was done, representing a novel combination ...
Monte Carlo Analysis of the Influence of Different Packaging on MOSFET Energy Response to X-rays and Gamma Radiation
(Polish Acad Sciences Inst Physics, Warsaw, 2012)
Radiation sensing MOSFETs have found numerous applications as detectors or device components in radiation fields used in nuclear industry, medical applications and space research. Monte Carlo simulations of MOSFET energy ...
Thermal, Ceramic and Technological Properties of Clays used in Production of Roofing Tiles - Principal Component Analysis
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2018)
This research describes a study of 11 selected samples of brick clays applied in roofing tile production, by using simultaneous thermal analysis. Additionally, the laboratory-sized samples were prepared and fired (850-950 ...
Effects of operation temperature on thermal expansion and main parameters of radial ball bearings
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2015)
The research of influence of operation temperature on the thermal expansion and main parameters of radial ball bearings is presented in this paper. The main bearing parameters are identified in accordance with the increasing ...