Претраживање
Приказ резултата 331-340 од 407
On biomimetics in machine elements design
(Manipal University Jaipur, India, 2019)
The aim of the paper is to point up the possibilities of biomimetics principles in the machine elements design. During last decades, the new requirements in machine elements design are placed in front of the experts. The ...
Gas cylinder rupture induced by local corrosion damage
(Society for Structural Integrity and Life – Prof. Dr Stojan Sedmak (DIVK), 2018)
Commercial gas cylinders are common type of pressure vessels in many health care and technical facilities. Unexpected
failures of gas cylinders occur despite of fact that the design, manufacture route, quality control, ...
Simulation of the kinematic hardening of AISI 316 steel by nonlinear finite element analysis
(Serbian Society of Mechanics and Faculty of Technical Sciences Novi Sad, Serbia, 2015)
The coupled non-linear transient calculation is performed and explained in order to simulate the kinematic hardening behavior of AISI 316 steel and the Finite Element Method (FEM) is used for presented simulation. The ...
Feasibility Analysis for Repair of Large Diameter Hydro Turbine Shaft Based on Weldability Test and Welding Cycle Simulation
(Advanced Materials Research, 2019)
Turbine and generator rotors and shafts undergo high stresses during regular working life
and, from a safety and operational aspect, are the most significant components of a power
generation system. Depending on the ...
Comprehensive approach to weld repair on elements of power transmission – case study for hydro turbine shaft
(Proceedings of the The 4th IIW South – East European Welding Congress, October, 10-13, 2018, Belgrade, 2018)
Turbine and generator rotors and shafts undergo high
stresses during regular working life and, from a safety
and operational aspect, are the most significant
components of a power generation system. Depending
on the ...
Theory of critical distances in analysis of the influence of tooth profile on gears bending capacity
(5th International Conference on Power Transmission BAPT2016, 2016)
The fatigue cracks and failures in tooth roots are still one of the most common problems in gear pairs operation.
Therefore, the application of new methods and up-to-date calculation procedures is welcome. This paper ...
Modal analysis of the hydro turbine shaft with cracks
(Abstracts of 14th International conference Dynamical Systems - Theory and Applications, 2017)
The design process for the elements which are the parts of the structures and equipment in power industry includes both of stress and strain state calculations, as well as an analysis of natural mode shapes and frequencies. ...
The effects of chemical composition and firing temperature in heavy clay brick production - Chemometric approach
(Expert Fachmedien GmbH, 2014)
Factors influencing final clay brick properties are numerous, since the raw materials are highly heterogeneous. The chemometric approach is rarely used in analysis in this field, although it could significantly improve ...
Elektrofilterski pepeo kao potencijalna sirovina za proizvodnju građevinskih materijala i keramike
(SRTOR VI - 6th Symposium “Recycling Technologies and Sustainable Development with International Participation” / 6. Simpozijum “Reciklažne tehnologije i održivi razvoj”, Zbornik radova, Soko Banja, Srbija, 2011)
Establishing the model for predicting the moisture and velocity in the critical point during drying of green masonry products
(Programme and book of abstracts, The Serbian Ceramic Society Conference “Advanced Ceramics and Application II”, Belgrade, 2013)
The aim of this study was to establish the model for predicting the moisture and velocity in the critical point during drying of green masonry products. The raw material was first dried at a temperature of 60°C, and then ...