Претраживање
Приказ резултата 11-19 од 19
Investigation of the Repair Welding Technology Using Ni Base Electrode
(Trans Tech Publications Ltd, Durnten-Zurich, 2013)
Metal materials are subjected to innumerable time-dependent degradation mechanisms when operate in power, petrochemical and refinery plant. These materials are subjected to multiaxial stresses, creep, fatigue, corrosion ...
Sensitivity analysis of mathematical models for final product properties: Link to DTG curve
(Elsevier Sci Ltd, Oxford, 2013)
Compressive strength and water absorption of fired heavy clay products varies with firing temperatures, but not entirely according to linear function, as it is mostly reported in literature. Also, differential thermo-gravimetric ...
Failure investigation of the bucket wheel excavator crawler chain link
(Pergamon-Elsevier Science Ltd, Oxford, 2013)
The high mobility of open pit machines in heavy duty conditions provides fertile ground for the occurrence of various failures of the traveling mechanisms' vital parts such as chain links. The goal of the study presented ...
Explicit parametric method for optimal spur gear tooth profile definition
(Trans Tech Publications Ltd, 2013)
The gear tooth profile has an immense effect on the main operating parameters of gear pairs (load capacity, working life, efficiency, vibrations, etc). In current engineering research and practice, there is a strong need ...
The influence of corrosion on stress concentration factor at shaft to flange radius
(Springer Netherlands, 2013)
This paper describes the influence of corrosion on stress concentration factor and crack initiation at shaft-flange transition section. The real turbine shaft failure case study is used for research. This case study and ...
Life extension of gears flank surfaces regenerated by hard facing
(Editura Stiintifica Fmr, Bucharest, 2013)
This paper contains the results of experimental analysis of fatigue endurance of used steel teeth regenerated by hard facing. The cylindrical spur gears were tested and compared with the newly made ones, oiler being ...
Methodological approach to recovery of the cracks on the turbine-shaft at hydroelectric power plant djerdap II
(Springer Netherlands, 2013)
In present paper, the methodological approach to analysis of the causes of failures and recovery of the damages has been presented using the example of the damage of the turbine-shafts construction. This approach can be ...
Optimization of the production process through response surface method: Bricks made of loess
(Elsevier Sci Ltd, Oxford, 2013)
Loess clays are commonly used to produce bricks. Heavy clays, taken at location near Zrenjanin, Serbia, are used as a representative raw material in this study. The sample, containing about 28% of clay sized particles, is ...
Influence of modifying methods on quality of eutectic and hypereutectic silumine for diesel engine pistons
(Maney Publishing, Leeds, 2013)
The results of the investigation of the influence of different modifiers (sodium, phosphorus, antimony and strontium) on the quality of AlSi12CuMgNi and AlSi18CuMgNi alloys, which are used for the production of pistons, ...