Претраживање
Приказ резултата 11-20 од 136
Analysis of current state and integrity evaluation for the supply tank of generation unit 6 of thermal power plant Nikola Tesla ”A”, Obrenovac
(Trans Tech Publications Ltd, 2014)
Stable supply tank, with volume V = 250 m3 and operating pressure p = 1,5 MPa, of generation unit 6 at thermal power plant 'Nikola Tesla A' in Obrenovac, is designed for water-steam working fluid. It was made of steel Č ...
Investigation of the Repair Welding Technology Using Ni Base Electrode
(Trans Tech Publications Ltd, Durnten-Zurich, 2013)
Metal materials are subjected to innumerable time-dependent degradation mechanisms when operate in power, petrochemical and refinery plant. These materials are subjected to multiaxial stresses, creep, fatigue, corrosion ...
Methodology for reparation of damaged sleeves and welded shield sections of guide vanes at hydropower plant DJERDAP 1
(Trans Tech Publications Ltd, 2014)
Vertical Kaplan turbines, manufactured in Russia and with nominal power of 200 MW, have been installed in 6 hydroelectric generating units at ’Djerdap 1’. During the refurbishment of hydropower plant experimental non-destructive ...
The effect of alternations in mineral additives (zeolite, bentonite, fly ash) on physico-chemical behavior of Portland cement based binders
(Elsevier Sci Ltd, Oxford, 2018)
Instrumental analyses accompanied by analytical modeling tools were employed to assess physico-chemical changes induced by variations in chemical composition of cementitious composites, i.e. mortar binders. Coal combustion ...
Analytical modeling of activation procedure applied in alpha-alumina thermo-mechanical synthesis
(Elsevier Sci Ltd, Oxford, 2015)
The impact of the mechanical processing parameters on the alumina grain-size distribution affiliated characteristics and on the gamma to alpha phase transformation rate was investigated. The moderation in the alumina samples ...
Validation of energy-dispersive X-ray fluorescence procedure for determination of major and trace elements present in the cement based composites
(Pergamon-Elsevier Science Ltd, Oxford, 2019)
Adjustment and subsequent validation of energy-dispersive X-ray fluorescence (ED-XRF) method for cement based binders with addition of mineral raw materials (fly ash, zeolite and bentonite) was conducted. Eighteen chemical ...
Chemometric analysis of the influence of mechanical activation on the mica quality parameters
(Elsevier Sci Ltd, Oxford, 2015)
The differences in the set of the process parameters measured before and after mica mechanical activation and their influence on the grain size distribution related characteristics have been studied. The modification of ...
Određivanje preciznosti metoda ispitivanja mehaničkih karakteristika opekarskih proizvoda i crepova od gline uporednim ispitivanjem / Determining brick and roof tile mechanical characteristics testing accuracy: Comparative investigation
(Udruženje inženjera građevinarstva, geotehnike, arhitekture i urbanista "Izgradnja", Beograd, 2011)
U okviru standarda SRPS ISO/IEC 17025:2006 - Opšti zahtevi za kompetentnost laboratorija za ispitivanje i laboratorija za etaloniranje, pod tačkom 5.9 postoji zahtev koji se odnosi na obezbeđenje poverenja u kvalitet ...
The possibility of obtaining. Composite al18wt%si/sic by compocasting process
(ModTech Publishing House, 2012)
The aim of this study was to investigate the influence of various process parameters on the microstructure of composite materials based on alloys All 8Wt%Si with the addition of 10Wt%SiC. The effect of stirring speed (1000 ...
Implementation of Preventive Maintenance in Network-Level Optimization Case Study of the Serbian Low-Volume Road Network
(Natl Acad Sciences, Washington, 2015)
Application of appropriate preventive maintenance treatments, at the right time, extends the service life of pavements, resulting in benefits to road users through increased ride comfort and safety and to road agencies ...