Претраживање
Приказ резултата 11-19 од 19
Influence of FSW parameters on formation quality and mechanical properties of Al 2024-T351 butt welded joints
(Elsevier, Amsterdam, 2013)
The influence of R/v ratio on joint quality in 2024-T351 aluminum alloy was studied. Specimens were subjected to friction stir welding with the rotation rates of 750, 950 and 1180 r/min and welding speed between 73 and 190 ...
Investigation of the Repair Welding Technology Using Ni Base Electrode
(Trans Tech Publications Ltd, Durnten-Zurich, 2013)
Metal materials are subjected to innumerable time-dependent degradation mechanisms when operate in power, petrochemical and refinery plant. These materials are subjected to multiaxial stresses, creep, fatigue, corrosion ...
Optimization of the production process through response surface method: Bricks made of loess
(Elsevier Sci Ltd, Oxford, 2013)
Loess clays are commonly used to produce bricks. Heavy clays, taken at location near Zrenjanin, Serbia, are used as a representative raw material in this study. The sample, containing about 28% of clay sized particles, is ...
Influence of modifying methods on quality of eutectic and hypereutectic silumine for diesel engine pistons
(Maney Publishing, Leeds, 2013)
The results of the investigation of the influence of different modifiers (sodium, phosphorus, antimony and strontium) on the quality of AlSi12CuMgNi and AlSi18CuMgNi alloys, which are used for the production of pistons, ...
Application of chromite in the production of refractory coatings
(Verlag Schmidt GmbH, 2013)
This work investigated the possibility of developing new chromite-based refractory coatings for hot metal casting applications. The coating composition and rheological properties were optimized by careful choice of binding ...
State Analysis and Integrity of Welded Structures of the Upper Ring of the Turbine Runner Guide Vane Apparatus of Hydroelectric Generating Set A6 on Hydro Power Plant Djerdap 1
(Trans Tech Publications Ltd, Durnten-Zurich, 2013)
During the refurbishment of the hydroelectric generating set A6 on HPP "Djerdap 1", for the state analysis and assessment of the level and causes of degradation of the structure of the vertical Kaplan turbine runner guide ...
Drying Process Modelling for Heavy Clay Products Using a New Thin Layer Drying Model
(Trans Tech Publications Ltd, Stafa-Zurich, 2013)
Drying results, determined on samples made of masonry clay from the locality "Banatski Karlovac", are presented in this study. Experimental investigations were carried out in a laboratory recirculation dryer in which drying ...
What to expect from heavy clay?
(Elsevier Sci Ltd, Oxford, 2013)
The need of testing the quality of brickclay arises in all brick factories, with the opening of new deposits. The analyses are both time and economically consuming, so the aim of this study was to shorten the procedure ...
Assessment of the effect of pitting corrosion on fatigue crack initiation in hydro turbine shaft
(Trans Tech Publications Ltd, 2013)
Energy efficiency is a key issue worldwide, and not confined solely to the realm of engineers. Past failures of mechanical power system components must be examined carefully in order to minimise future occurrences and ...