Претраживање
Приказ резултата 11-20 од 38
Mix design and engineering properties of ultra high performance self compacting concrete
(Czech Concrete Soc-Ceska Betonarska Spolecnost Cssi, Prague 1, 2011)
The mechanical properties (compressive strength and flexural strength) were investigated under different curing conditions (standard and steam curing). Silica fumes have characteristics that make them necessary in cement ...
Microstructure analysis and crack detection in turbine blades after prolonged exposure in plant
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
Turbine blades are one of the most important machine parts in every power generator. Corrosion and/or erosion attack on blades are also available in moisture atmosphere, because the wet water vapour is an usual working ...
Review of results of interlaboratory comparisons of national accredited laboratorys in the free field noise level measurements
(IEEE, NEW YORK, 2015)
Interlaboratory comparisons in the field of enviromental noise level measurements were organized by IMS Institute in Belgrade in August this year as a part of the standard noise monitoring according to of the method given ...
Determination of LCF Plastic and Elastic Strain Components of Steel
(Springer Science and Business Media B.V., 2022)
The behavior of steel in low-cycle fatigue (LCF) is tested experimentally, in accordance with ISO 12106:2017 (E) and/or ASTM E 606-04. For this purpose, smooth specimens which are exposed to low-cycle fatigue at several ...
Drying kinetic simulation of clay tiles made from the raw material having less clay fraction
(Trans Tech Publications Ltd, 2014)
In order to describe the internal moisture rate and to take all different mechanisms of moisture movement into account, it is suitable to use effective diffusivity as a measure of moisture rate, irrespectively of the ...
Quantification of stress raiser influence on decrease of machine parts fatigue life
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
This paper displays the usage of Theory of Critical Distances (TCD) in the prediction of high-cycle fatigue behaviour in machine parts and systems. It is possible to gain real overview of stresses of machine parts by Finite ...
The influence of corrosion on stress concentration factor at shaft to flange radius
(Springer Netherlands, 2013)
This paper describes the influence of corrosion on stress concentration factor and crack initiation at shaft-flange transition section. The real turbine shaft failure case study is used for research. This case study and ...
Prediction of crack initiation in spur gear contact zone
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
The objective of this paper is to give a new viewpoint in contact fatigue prediction in the case of high-cycle fatigue. The presented research is based on up-to-date methods and multidisciplinary approach, and enables ...
HSLA Steel - Simulation of Fatigue
(Springer, 2020)
In present paper, based on the results of the experimental study of the behaviour of the samples made of a HSLA steel, in the form of round smooth specimens (RSS) under LCF conditions (with controlled and completely ...
Determination of the optimal drying condition during drying of green masonry products
(ModTech Publishing House, 2012)
Explanation of the drying process is reduced to the establishment of a series theoretical and empirical drying models. Complex processes of simultaneous mass and energy transfer, which are often non-stationary and the ...