Претраживање
Приказ резултата 21-30 од 31
Application of neural networks in determination of compressive strength of concrete
(Revista Romana de Materiale/ Romanian Journal of Materials, 2012)
This paper presents the optimization of concrete mixtures composition related to a physical property and the process of production of trial mix design by using the multi-layered feed-forward neural networks. This optimization ...
Failure analysis of hydraulic turbine shaft
(Pergamon-Elsevier Science Ltd, Oxford, 2012)
This paper describes the analysis of major failure of 28 MW horizontal hydro turbine shaft. The analysis of load carrying capacity of critical radius and fractography analysis are presented. Special emphasize is on ...
Impact of choice of stabilized hysteresis loop on the end result of investigation of high-strength low-alloy (HSLA) steel on low cycle fatigue
(Croatian Metallurgical Soc, Zagreb, 2014)
High strength low-alloy steel under low cycle fatigue at a certain level of strain controlled achieve stabilized condition. During the fatigue loading stabilized hysteresis loop is determined, which typical cycle of ...
Geometry, mechanical properties and mounting of perforated plates for ballistic application
(Elsevier Sci Ltd, Oxford, 2010)
In this paper, the ballistic resistance of perforated plates made of different types of steel, mounting and geometry was investigated. Different types of steel in various heat treatment conditions were tested. Target ...
Wire fence as applique armour
(Elsevier Sci Ltd, Oxford, 2010)
In this paper, the behaviour of wire fence was investigated for potential as applique armour. The wire fence used was made from commercial high-strength patented wire and the supporting frames were made of mild steel ...
Experimental and numerical thermo - mechanical analysis of friction stir welding of high - strength alluminium alloy
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
This paper presents experimental and numerical analysis of the change of temperature and force in the vertical direction during the friction stir welding of high-strength aluminium alloy 2024 T3. This procedure confirmed ...
Novel Approach for Determination of Potentially Toxic Elements via ICP-OES in Aqueous Solutions of Building Materials with Industrial Byproduct Addition
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2019)
New global tendencies for waste materials reusing in building materials are imposing the request for improved performances of chemical analysis methods and the improvements of matrices used. A new method for optical emission ...
Thermal and Mechanical Behavior of Composite Mortars Containing Natural Sorptive Clays and Fly Ash
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2019)
Mineral additives are extensively applied as cement replacement materials in both construction concrete and mortar. Fly ash is one of the most commonly utilized additives which improve Theological properties, as well as ...
Mechanical Properties and Microstructure Fractal Analysis of Refractory Bauxite Concrete
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2015)
The surface topography analysis via fractals as a means of explanation of composite materials mechanical and microstructural characteristics has hardly been reported so far. This study proposes a method of fractal analysis ...
Procedure for setting up the drying regime that is consistent with the nature and properties of the clay raw material
(Taylor & Francis Inc, Philadelphia, 2018)
Over the past three decades, traditional ceramic facilities, such as chamber and tunnel dryers, are improved. Better thermotechnical equipment, operational strategies, and reliable scale-up methodologies have lead to higher ...