Претраживање
Приказ резултата 21-30 од 37
Mathematical approach to application of industrial wastes in clay brick production-Part II: Optimization
(Elsevier Sci Ltd, Oxford, 2015)
The effects of organic and inorganic waste sludges, coal dust, fly and landfill ashes, soybean crust, sawdust, sunflower flakes and their ash addition to representative heavy clay were investigated. Changes introduced to ...
Uticaj geometrije trna alata na mehaničke i strukturne karakteristike sučeonog spoja aluminijumske legure 2024-T351 zavarenog postupkom FSW / Influence of pin geometry on mechanical and structural properties of butt friction stir welded 2024-T351 aluminum alloy
(Savez hemijskih inženjera, Beograd, 2015)
U radu je ispitivano kakav zajednički, kombinovani uticaj brzina rotacije alata, brzina zavarivanja i mala promena u geometriji trna alata imaju na zavarljivost, mehaničke i strukturne karakteristike sučeonog spoja Al ...
Mechanical Properties and Microstructure Fractal Analysis of Refractory Bauxite Concrete
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2015)
The surface topography analysis via fractals as a means of explanation of composite materials mechanical and microstructural characteristics has hardly been reported so far. This study proposes a method of fractal analysis ...
Novel Utilization of Fly Ash for High-Temperature Mortars: Phase Composition, Microstructure and Performances Correlation
(Wiley, Hoboken, 2015)
In this study, the feasibility of using fly ash to manufacture high-temperature mortars was investigated. The investigation was set to define preliminary characteristics of new types of mortars based on ordinary and/or ...
Stress concentration factors in re-evaluation of design solution
(Serbian Society of Mechanics and Faculty of Technical Sciences Novi Sad, 2015)
The failures of various parts of mechanical systems in powe industry are the lessons that should be learned thoroughly. Every behaviour of structure close to design encelope must be ecxamined carefully in order to minimize ...
Simulation of the kinematic hardening of AISI 316 steel by nonlinear finite element analysis
(Serbian Society of Mechanics and Faculty of Technical Sciences Novi Sad, Serbia, 2015)
The coupled non-linear transient calculation is performed and explained in order to simulate the kinematic hardening behavior of AISI 316 steel and the Finite Element Method (FEM) is used for presented simulation. The ...
The effect of amorphous kaolin on properties of cement-based composites
(3rd International Conference of the Serbian Society for Ceramic Materials -, 2015)
Deciding the order of interventions on the structure of reinforced concrete (RC) bridges for earthquake conditions
(MASE 16, International Symposium of Macedonian Association of Structural Engineers, Ohrid, Macedonia, 2015)
A multitude of existing bridges fail to meet the criteria of seismic resistance, as designed according to
inadequate regulations, which eventually led to the reduction in their resistance. This practice requires
interventions ...
Non-typical defects on surfaces of ceramic and roof tiles: Nature and the causes
(ModTech Publishing House, 2015)
This research was conducted to identify the nature and the cause of non-typical defects which appeared on the visible surfaces of ceramic and roof tiles. Microstructural analysis was conducted via optical microscope and ...
Analiza performansi oštećenih objekata, primenom scenarija povezanih nelinearnih analiza i koeficijenta oštećenja
(Građevinski materijali i konstrukcije, 2015)
U radu je razvijena i prikazana metodologija za analizu oštećenja objekata koji su izloženi incidentnom i seizmičkom dejstvu. Procedura se bazira na nelinearnim numeričkim analizama, uvažavajući principe projektovanja ...