Претраживање
Приказ резултата 11-20 од 28
The influence of corrosion on stress concentration factor at shaft to flange radius
(Springer Netherlands, 2013)
This paper describes the influence of corrosion on stress concentration factor and crack initiation at shaft-flange transition section. The real turbine shaft failure case study is used for research. This case study and ...
Prediction of crack initiation in spur gear contact zone
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
The objective of this paper is to give a new viewpoint in contact fatigue prediction in the case of high-cycle fatigue. The presented research is based on up-to-date methods and multidisciplinary approach, and enables ...
Establishing a method for determination of effective diffusion coefficiente
(ModTech Publishing House, 2011)
The aim of this paper is to calculate the effective diffusion coefficient for typical masonry clay on the base of experimentally recorded drying curves. Two computer programs for calculation of diffusion coefficient, which ...
Integrated LCA and LCCA network level pavement maintenance model
(CRC Press/Balkema, 2019)
Pavement management systems tend to lead to sound decision making regarding the optimal maintenance strategy which is, in most cases, based on the achievement of minimal total society costs which are defined as the sum of ...
The possibility of obtaining. Composite al18wt%si/sic by compocasting process
(ModTech Publishing House, 2012)
The aim of this study was to investigate the influence of various process parameters on the microstructure of composite materials based on alloys All 8Wt%Si with the addition of 10Wt%SiC. The effect of stirring speed (1000 ...
Effect of changes in matric suction on slope stability in natural unsaturated soil
(ICE Publishing, 2015)
Stability analyses were performed for a real engineering-geological cross-section of unsaturated Quaternary silt sediments. Unsaturated shear strength is a function of the two stress variables: net normal stress and matric ...
Determination of apparent porosity level of refractory concrete using ultrasonic pulse velocity technique and image analysis
(American Ceramic Society, 2011)
Aim of this paper is to establish the correlation between sintering process, porosity and important thermo-mechanical property of refractory concrete, i.e. creep. Creep deformation was investigated according to standard ...
The failures of a supporting structure of a coal-reloading bridge and methodological approach to recovery of the damages
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
In present paper, methodological approach to the analysis of the failures and recovery of the damages has been presented on an example of fracture and damage of a structure of the reloading bridge. The approach presented ...
Determination of the optimal drying condition during drying of green masonry products
(ModTech Publishing House, 2012)
Explanation of the drying process is reduced to the establishment of a series theoretical and empirical drying models. Complex processes of simultaneous mass and energy transfer, which are often non-stationary and the ...
Compressive Strength Improvements of Cement-Based Composites Achieved with Additional Milling of Metakaolin
(Springer, Dordrecht, 2018)
Kaolin from a Serbian deposit, having a high content of mica and quartz, disordered kaolinite and a high specific surface area, was used to prepare metakaolin (MK). The calcination at temperatures of 700 degrees C or 750 ...