Pretraživanje
Prikaz rezultata 221-230 od 251
Impact of CO2 Emissions on Low Volume Road Maintenance Policy: Case Study of Serbia
(Sage Publications Inc, Thousand Oaks, 2019)
About 20% of the Serbian national road network has sections with low volume traffic. These sections are maintained in relatively poor condition since the maintenance budget is typically allocated to the road sections with ...
Economical and ecological aspects of use of bio-lubricants and conventional lubricants
(Goriva i maziva, 55, 3, 2016)
It is believed that more than 50% of produced lubricants during or/and after the operation is due directly or indirectly to the environment. For these reasons, in areas where the application of lubricant is related to the ...
Novel Utilization of Fly Ash for High-Temperature Mortars: Phase Composition, Microstructure and Performances Correlation
(Wiley, Hoboken, 2015)
In this study, the feasibility of using fly ash to manufacture high-temperature mortars was investigated. The investigation was set to define preliminary characteristics of new types of mortars based on ordinary and/or ...
Analiza postupka ocenjivanja životnog ciklusa opekarskih proizvoda
(Izgradnja, 2019)
Poznato je da se u proizvodnji opekarskih proizvoda koriste velike količine sirovina koje takođe uključuju visoku potrošnju energije što se negativno odražava na kvalitet životne sredine. Ocenjivanje životnog ciklusa (eng. ...
Primena postupaka za izdavanje eko-deklaracija za građevinske proizvode / Application of procedures for issuing eco-declarations for construction products
(Udruženje inženjera građevinarstva, geotehnike, arhitekture i urbanista "Izgradnja", Beograd, 2018)
Postupci za pripremu eko-deklaracija za građevinske proizvode i zgrade zasnovani su na standardizovanim metodama. Deklaracije proizvoda o zaštiti životne sredine (EPD) pripadaju tipu III eko-deklaracija. EPD sadrži ...
Spur gear model for prediction of fatigue damage initiation in contact zone
(International Journal of Powertrains – „Special Issue on Technologies and Models for High Power Density Geared Powertrains", 2016)
The objective of this paper is to give a new viewpoint in contact fatigue assessment in the spur gears. The presented research is based on up-to-date methods and multidisciplinary approach, and enables direct prediction ...
Procedure for setting up the drying regime that is consistent with the nature and properties of the clay raw material
(Taylor & Francis Inc, Philadelphia, 2018)
Over the past three decades, traditional ceramic facilities, such as chamber and tunnel dryers, are improved. Better thermotechnical equipment, operational strategies, and reliable scale-up methodologies have lead to higher ...
Development of the universal tool for testing of tensile properties of hexagonal steel wire mesh for civil engineering
(Savez inženjera metalurgije Srbije, Beograd, 2018)
The developing of the universal tool for testing of tensile properties of hexagonal steel wire mesh for civil engineering is described in this paper. The developed tool allows repeated testing of hexagonal steel wire mesh ...
Feasibility Analysis for Repair of Large Diameter Hydro Turbine Shaft Based on Weldability Test and Welding Cycle Simulation
(Advanced Materials Research, 2019)
Turbine and generator rotors and shafts undergo high stresses during regular working life
and, from a safety and operational aspect, are the most significant components of a power
generation system. Depending on the ...
The effects of chemical composition and firing temperature in heavy clay brick production - Chemometric approach
(Expert Fachmedien GmbH, 2014)
Factors influencing final clay brick properties are numerous, since the raw materials are highly heterogeneous. The chemometric approach is rarely used in analysis in this field, although it could significantly improve ...