Претраживање
Приказ резултата 31-40 од 42
The influence of the raw material grinding fineness on the brick industry products quality
(Trans Tech Publications Ltd, Durnten-Zurich, 2002)
The brick industry development trends have two main directions: high product quality and use of lower quality clays and secondary (recycled) raw materials, The development trends reflect today's market requirements - ...
Preparation of flish sediments and their application in brick products manufacturing
(Trans Tech Publications Ltd, Durnten-Zurich, 2004)
Flish sediments represent atypical raw materials: marls, marly shales and shales. This paper presents the results of laboratory tests of shales. The paper points out the similarities and differences in technological ...
Static and impact crack properties of a high-strength steel welded joint
(Elsevier Sci Ltd, Oxford, 2007)
in order to gain the benefits of weldable high-strength steels in pressurized equipment applications, satisfactory toughness and crack properties of the welded joint, both in the weld metal and the heat-affected-zone (HAZ), ...
Geometry, mechanical properties and mounting of perforated plates for ballistic application
(Elsevier Sci Ltd, Oxford, 2010)
In this paper, the ballistic resistance of perforated plates made of different types of steel, mounting and geometry was investigated. Different types of steel in various heat treatment conditions were tested. Target ...
Wire fence as applique armour
(Elsevier Sci Ltd, Oxford, 2010)
In this paper, the behaviour of wire fence was investigated for potential as applique armour. The wire fence used was made from commercial high-strength patented wire and the supporting frames were made of mild steel ...
Experimental and numerical thermo - mechanical analysis of friction stir welding of high - strength alluminium alloy
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
This paper presents experimental and numerical analysis of the change of temperature and force in the vertical direction during the friction stir welding of high-strength aluminium alloy 2024 T3. This procedure confirmed ...
Failure analysis of the end eye connection of the bucket wheel excavator portal tie-rod support
(Pergamon-Elsevier Science Ltd, Oxford, 2009)
This paper describes the failure analysis results of the bucket wheel excavator (BWE) portal tie-rod support. The results of finite elements analysis (FEA) point out the occurrence of pronounced stress concentration, whereby ...
Novel Approach for Determination of Potentially Toxic Elements via ICP-OES in Aqueous Solutions of Building Materials with Industrial Byproduct Addition
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2019)
New global tendencies for waste materials reusing in building materials are imposing the request for improved performances of chemical analysis methods and the improvements of matrices used. A new method for optical emission ...
Thermal and Mechanical Behavior of Composite Mortars Containing Natural Sorptive Clays and Fly Ash
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2019)
Mineral additives are extensively applied as cement replacement materials in both construction concrete and mortar. Fly ash is one of the most commonly utilized additives which improve Theological properties, as well as ...
Mechanical Properties and Microstructure Fractal Analysis of Refractory Bauxite Concrete
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2015)
The surface topography analysis via fractals as a means of explanation of composite materials mechanical and microstructural characteristics has hardly been reported so far. This study proposes a method of fractal analysis ...