Претраживање
Приказ резултата 1-10 од 17
Process parameters influence on microstructural properties of hypereutectic al-18wt% Si alloys obtained by rheocasting process
(Editura Stiintifica Fmr, Bucharest, 2012)
Hypereutectic Al-18wt%Si alloy was obtained by conventional and rheocasting procedure at cooling rate 0.16 +/- 0.05 degrees Cs-1. Samples of rheocasted alloy were obtained at two stirring speeds 1000 and 1500 rpm. Tests ...
Quantification of stress raiser influence on decrease of machine parts fatigue life
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
This paper displays the usage of Theory of Critical Distances (TCD) in the prediction of high-cycle fatigue behaviour in machine parts and systems. It is possible to gain real overview of stresses of machine parts by Finite ...
Prediction of crack initiation in spur gear contact zone
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
The objective of this paper is to give a new viewpoint in contact fatigue prediction in the case of high-cycle fatigue. The presented research is based on up-to-date methods and multidisciplinary approach, and enables ...
The possibility of obtaining. Composite al18wt%si/sic by compocasting process
(ModTech Publishing House, 2012)
The aim of this study was to investigate the influence of various process parameters on the microstructure of composite materials based on alloys All 8Wt%Si with the addition of 10Wt%SiC. The effect of stirring speed (1000 ...
Concrete paving blocks and flags made with crushed brick as aggregate
(Construction and Building Materials, 2012)
Demolition of old buildings in urban cores has produced a large amount of waste material. Since they are mostly masonry structures the largest part of the waste material is ceramic waste. Besides that, ceramic waste is ...
Dehydration investigations of a refractory concrete using DTA method
(Springer, Dordrecht, 2012)
The base mix refractory concrete is corundum-based, containing corundum as refractory aggregate and CAC as hydraulic binder, with a spinel as an additive. The authors investigated the dehydration reactions which occur from ...
Synthesis, characterization and application of the filler based on corundum for obtaining the ceramic coats in foundry
(Editura Stiintifica Fmr, Bucharest, 2012)
In this work, a possibility to develop new ceramic coats based corundum for casting applications has been examined. Optimization of coating composition with controlled rheological properties was attained by applying different ...
The failures of a supporting structure of a coal-reloading bridge and methodological approach to recovery of the damages
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
In present paper, methodological approach to the analysis of the failures and recovery of the damages has been presented on an example of fracture and damage of a structure of the reloading bridge. The approach presented ...
Determination of the optimal drying condition during drying of green masonry products
(ModTech Publishing House, 2012)
Explanation of the drying process is reduced to the establishment of a series theoretical and empirical drying models. Complex processes of simultaneous mass and energy transfer, which are often non-stationary and the ...
The possibility of substitution of wear resistant low chromium white iron resistant with basalt melt
(Editura Stiintifica Fmr, Bucharest, 2012)
In this study the testing results of the possibility of substituting mill lining plates for ore milling made of low chromium white iron that is resistant to wear with plates made of basalt melt are presented. Plates made ...