Pretraživanje
Prikaz rezultata 11-20 od 42
Wire fence as applique armour
(Elsevier Sci Ltd, Oxford, 2010)
In this paper, the behaviour of wire fence was investigated for potential as applique armour. The wire fence used was made from commercial high-strength patented wire and the supporting frames were made of mild steel ...
Experimental and numerical thermo - mechanical analysis of friction stir welding of high - strength alluminium alloy
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
This paper presents experimental and numerical analysis of the change of temperature and force in the vertical direction during the friction stir welding of high-strength aluminium alloy 2024 T3. This procedure confirmed ...
Has the latest global financial crisis changed the way road public-private partnerships are funded? A comparison of Europe and Latin America
(Elsevier Sci Ltd, Oxford, 2020)
A financial/economic crisis may have an adverse effect on transport public-private partnerships (PPPs) as both traffic demand is negatively influenced, and governments are further under pressure. However, research on awarded ...
Cavitation damages morphology of high-strength low-alloy steel
(Faculty of Metallurgy, 2016)
This paper presents the research into behaviour of HSLA steel affected by cavitation. The parent material (PM) and simulated heat-affected zone (SHAZ) were studied. Ultrasonic vibratory cavitation test was performed in ...
Dehydration investigations of a refractory concrete using DTA method
(Springer, Dordrecht, 2012)
The base mix refractory concrete is corundum-based, containing corundum as refractory aggregate and CAC as hydraulic binder, with a spinel as an additive. The authors investigated the dehydration reactions which occur from ...
Comparative analysis of process parameters of talc mechanical activation in centrifugal and attrition mill
(Oficyna Wydawnicza Politechniki Wroclawskiej, Wroclaw, 2014)
The efficiency of talc mechanical activation by means of two different mechano-activators centrifugal and attrition mill is investigated in this study and the comparative analysis of the characteristics of obtained talc ...
Mechanical Activation as Sintering Pre-treatment of Talc for Steatite Ceramics
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2014)
The effect of vibratory mill induced mechanical activation on the change of the particle size, crystallinity and the phase transformations of the minerals present in the activated material, was studied with the purpose of ...
Failure analysis of the end eye connection of the bucket wheel excavator portal tie-rod support
(Pergamon-Elsevier Science Ltd, Oxford, 2009)
This paper describes the failure analysis results of the bucket wheel excavator (BWE) portal tie-rod support. The results of finite elements analysis (FEA) point out the occurrence of pronounced stress concentration, whereby ...
Synthesis and characterization of new refractory coatings based on talc, cordierite, zircon and mullite fillers for lost foam casting process
(Polska Akad Nauk, Polish Acad Sciences, Inst Metall & Mater Sci Pas, Warszawa, 2014)
Refractory coatings based on different refractory fillers (talc, cordierite, zircon and mullite) for application in Lost Foam casting process were investigated. Design and optimization of the coatings composition with ...
Investigation of thermally induced processes in corundum refractory concretes with addition of fly ash
(Springer, Dordrecht, 2015)
The effects that the fly ash addition has on the behavior of thermally resistant corundum concrete were discussed. Experimental program implied production of two refractory composites: "referent" concrete from 20 % of ...